Pioneer VSA-AX10Ai manual Using multi operations, Press OK when you’re finished, Multi Operation

Controlling other equipment 07

•You don't need to program the amplifier to switch to the input function selected in step 2, or to switch on or off. This is done automatically.

With Pioneer components, you don’t need to:

•program the power to switch off in a shutdown sequence;

•program the power to switch on if it’s the source component selected in step 2;

•program a Pioneer TV or monitor to switch on if the input function (selected in step 2) has video input terminals;

These take priority in multi operations (not shutdown).

5If necessary, add a delay between operations by pressing ‘Delay’.

Some components may take a few seconds to switch on or off, or perform certain operations. In these cases, you may want to add a slight delay (up to sixty seconds is possible) between commands.

Use the + and – buttons on the Delay Time screen to adjust the delay time then press OK.

DVD/LD

MULTI OPERATION

Delay Time

– 0.1 sec +

OK CANCEL

•If you want to change the delay time after it’s been set, press the delay time, then press SET to come back to this screen.

6Repeat steps 3 to 5 for additional commands. As each command is entered, they will appear in order on the remote touch screen.

DVD/LD

MULTI OPERATION

DVD -

PLAY

Delay - 2.0sec

Add Replace Run

Delete Delay OK

•To add a new command above another command, press the existing command before pressing Add.

•To erase a command, select the operation you want to erase and press Delete.

•Commands will be stored regardless of how you exit from this screen.

7 Press OK when you’re finished.

PLEASE WAIT shows in the remote display while the multi operation is stored and you’ll return to step 2.

Using multi operations

You can start multi operations with the amplifier switched on, or in standby.

1From the remote control Home menu press

MULTI OPERATION.

HOME 1/3

AMPLIFIER AMPLIFIER

INPUT 1		2	3
DVD		TV	SAT
/ LD		/ DVD
DVR		CD	TUNER
/ VCR1
TV		MULTI	SYSTEM
CONT	OPERATION		OFF

SETUP

2Press a function button that has been set up with a multi operation.

The amplifier switches on (if it was in standby) and the programmed multi operation is performed automatically.

MULTI OPERATION

Select Function

DVD	TV	SAT
/ LD	/ DVD
DVR	CD	TUNER
/ VCR1
VCR2	VCR3	CD-R
		/ TAPE1
VIDEO	MULTI CH	TV
	INPUT	CONT

CANCEL

•To test the sequence before confirming it, press Run.

•To replace a command in the sequence, select the command then press Replace. Add the operation as shown in the steps above.

67

En