Model NT3 Series
BATTERY INSTALLATION
Your NAUTICO3 radio operates with either 4 AA alkaline batteries or an optional NiMH battery pack. The belt clip should be removed (see below) to ease installation or removal of the batteries.
To install the batteries:
1.With the back of the radio facing you, remove the belt clip (see diagram below) for easy access, then remove the Battery Cover by pulling down the Battery Cover Latch and lifting up the Battery Cover from the radio.
2.Insert 4 AA batteries observing the polarity as shown. Installing the batteries incorrectly will prevent the radio from operating or may damage the radio.
3.Return the Battery Cover by sliding it up on the radio and push up the Battery Cover Latch until it locks into place. Replace the belt
clip, making sure it locks into place. | BATTERY COVER |
|
One Battery inserted in this slot
BATTERY
COMPARTMENT
BATTERY COVER
LATCH
BELT CLIP
LOCK TAB
INSTALLING THE BELT CLIP
To install the BELT CLIP, slide the clip down into the slot on the back of the radio until the BELT CLIP LATCH clicks. To remove the BELT CLIP, press the LOCK TAB up, then gently pull the belt clip up toward the top of the radio.
BELT CLIP
LATCH
Page 6 | midlandusa.com |