OPERATION _______________________________________________
Adjusting the volume
1Adjust the volume using »VOLUME « (on the right side of the device).
Adjusting the tone
1Adjust the tone using »TONE LOW HIGH« (on the right side of the device).
Listening with earphones
1Insert the earphone plug (ø 3.5 mm, stereo) into the »0« jack on the left of the device.
– This automatically switches off the loudspeakers.
Switching between stereo and mono reception
FM stereo reception is only available with earphones.
1Connect the earphones and select an FM station.
2Set the »MONO/STEREO« switch (on the left of the device) to stereo.
–Display: » 
«.
3If the reception of the station is weak in FM stereo, move the »MONO/STEREO« switch (on the left of the device) to mono.
–Display: » 
« disappears from the display.
Setting the reception sensitivity
1Set the »DX./LO.« switch (on the left of the device) to »DX.«.
– The sensitivity is set to high, in other words,
2If the signal is too strong, and is causing distortion, move the »DX./ LO.« switch to »LO.« (low sensitivity).
Special features of SW reception
Short wave reception
Your radio can receive signals in a number of frequency bands. It is easy to get used to tuning to stations in the FM, MW and LW bands, since they are always on the same frequencies.
Unfortunately, this is not always the case with short wave stations. Due to atmospheric conditions, short wave stations must frequently broadcast on different wavelengths. Most short wave bands are available all over the world and can be used by international broadcasters. At present these are the only wavelengths which provide listeners with direct reception over long distances. For this reason, short wave frequencies are not only used by radio stations, but also by other users such as amateur radio enthusiasts, shipping, aircraft and radio navigation systems.
32