Polk Audio M10, M20 owner manual Top of speaker Speaker

Wall mounting the M10 Bookshelf Loudspeaker

The M Series Bookshelf Loudspeakers feature a built-in keyhole slot for easy wall mounting. When wall mounting, we recommend using either bare wire or spade lug connections to ensure flush mounting. Follow the steps below to safely wall mount these speakers. Wall mounting requires basic skills with tools such as a drill and a screwdriver. If you are in doubt that you possess the necessary skills or tools, con- sult your Polk Audio dealer, or a professional installer.

•Make sure the material on which you plan to mount the speakers (plaster, drywall, paneling, stone, etc.) can support the weight of the speakers (M10=approx 9lbs/4kg ea)

•Make sure the locations you select do not conceal electrical wiring or plumbing.

•Prior to installation, hold the speaker in the chosen location to make sure it safely clears obstacles such as ceiling, adjacent walls, corners, beams, lighting fixtures and door/window frames.

•Each speaker has a keyhole mounting slot on the back panel. The slot appears centered approximately 3 1/4" from the left corner of the M10. Use these measurements to mark to your mounting location, being sure to leave approximately 1-2" of clearance above the speaker to compensate for the function of the keyhole slot.

•If you are certain that there is a stud behind the wall surface, drive #10 sheet metal screws (not included) through the wall and into the stud [figure 2a].

•If there is no stud behind the wall at the chosen location, install #10 wall

anchors (not supplied) into the wall by following the wall-anchor-manufacturer’s instructions. [figure 2b].

•Tighten screws into stud or wall anchors, leaving screw heads protruding 1" to 2" to leave room for attached wire and ensure that the screw fits into the keyhole slot. The speaker should mount flush to the wall.

•Line up the keyhole slot so that the screw head passes through the large center hole of the slot.

•Let the speaker slide straight down, allowing the screw head to slip

behind the smaller end of the keyhole slot [figure 3].

•Tug gently on the speaker to make certain that the speaker is secure.

•If the speaker is not held snug against the wall by the screw heads, remove the speaker from the wall, drive the screws in a little further and then remount the speaker.

Top of speaker

speaker			M10
			1.5"
side of	M10	3.25"	Keyhole
			slot
Left

Use #10 screw for wall stud, use #10 wall anchors & screw for no wall stud.

Use tornillos N° 10 cuan- do haya parales internos en la pared, use tornillos y anclas N° 10 cuando no haya parales internos.

Utilisez des vis #10 pour	Für Wandpfosten	Se la parete è di legno,
fixation sur un montant	#10 Schrauben	usare viti N. 10, altrimenti
ou, en absence de mon-	verwenden. Falls	usare viti e ancoraggi
tant, des vis #10 avec	kein Wandpfosten	appositi N. 10.
chevilles.	vorhanden ist,
	#10 Maueranker
	und Schrauben
	verwenden.

Utilize um parafuso 10 para viga na parede ou um parafuso 10 com âncora se não houver viga.

Slide the speaker down on the screw heads to catch the keyhole slots.

Clean cabinets with

a damp cloth. Avoid harsh detergents and cleaning fluids. Vacuum grilles to remove dust.

Deslice el altavoz sobre las cabezas de los tornil- los para que encajen en las ranuras en forma de ojo de cerradura.

Limpie las cajas con un paño húmedo. Evite los detergentes fuertes y los líquidos de limpieza. Pásele la aspiradora a las rejillas para quitarles el polvo.

Glissez les enceintes sur	Den Lautsprecher	Fare scorrere l’altopar-
les têtes de vis jusqu'à ce	mit den Schlüssel-	lante verso il basso sulla
que les encoches en trou	lochschlitzen auf die	testa della vite in modo
de serrure s'enclenchent.	Schraubenköpfe	che questa si introduca
	setzen und nach unten	nell’apposita scanalatura.
	schieben.

Nettoyez les enceintes	Die Gehäuse mit einem	Pulire le casse con un
avec un linge humide.	feuchten Tuch reinigen.	panno umido. Non usare
N'utilisez jamais de déter-	Scharfe Reinigungsmittel	né detergenti forti né liq-
gent abrasif ou de nettoy-	und -flüssigkeiten	uidi per pulizia. Per rip-
ant. Dépoussiérez	vermeiden. Mit einem	ulire le griglie dalla
délicatement les grilles à	Staubsauger den Staub	polvere usare un
l'aspirateur.	von den Abdeckungen	aspirapolvere.
	entfernen.

Deslize a caixa sobre a cabeça do parafuso até encontrar o furo de encaixe.

Limpe as caixas com um pano úmido. Evite produ- tos de limpeza fortes.

Passe o aspirador de pó nas telas para remover a poeira.

for more information and accessories: www.polkaudio.com