Icom IC-F3062S, IC-F3061T Optional Unit Installation, UT-96R, UT-109R and UT-110R installation

Page 7

SECTION 4 OPTIONAL UNIT INSTALLATION

CAUTION! Optional unit installation should be done at authorized Icom servise center only.

The waterproof capability of the transceiver cannot be guaranteed if you install an unit yourself, or have it done at a non-authorised dealer/service center.

Install the optional unit as follows.

q Rotate [VOL] to turn the power OFF, and remove the battery pack. w Remove the anntena and antenna nut A.

e Remove the rotary selector B and volume control C.

r Unscrew two screws D, then take off the chassis from the front panel in the direction of the arrow. BE CAREFUL! Flat cable is connected between the MAIN unit on the chassis and front panel.

D

A

B C

tInstall the optional unit as below.

• UT-96R, UT-109R and UT-110R installation*

DO NOT attach the unit to the connector “J2.“ Otherwise no TX modu- lation or AF output is available.

• UT-119S/H installation

DO NOT attach the unit to the connector “J1.“ Otherwise no TX modu- lation or AF output is available.

J1

*;The following PC bord modification is required when installing optional UT-109R and UT-110R.

Cut the pattern on the PC board at “MIC“ and “AFOUT“ as shown below.

AFOUT

MIC

NOTE: When uninstalling the unit

Be sure to re-solder the disconnected points as below when you remove the unit. Otherwise, no TX modulation or AF output is available.

Re-solder

4 - 1

Page 6 Page 8
Image 7
Page 6 Page 8
Contents VHF Transceiver Introduction Table of Contents USA-01, GEN-01 EUR-01 Section SpecificationsFront Unit Section Inside ViewsRemoving the Chassis Unit Disassembly InstructionsUT-96R, UT-109R and UT-110R installation Optional Unit InstallationRF Circuit Main Unit Receiver CircuitsFM if IC IC3 Dtmf Squelch Circuit Noise SquelchTone Squelch CTCSS/DTCSTX VCO Modulation Circuit Main UnitTransmit Amplifiers RF Unit APC Circuit RF UnitPLL Circuit Power Supply Circuits Main UnitPLL Circuit Main Unit 2 D/A Converter Main Unit IC20 Port AllocationsExpand IC Front Unit IC505 Preparation Adjustment ProceduresConnection PC Screen Example Frequency Frequency AdjustmentPower Transmit AdjustmentConvenient Receive AdjustmentFront Unit Parts ListOrder Description Location Main UnitMain Unit Main Unit Main Unit SKHLLFA010 Main Unit RF UnitJack Unit VR Unit Main UnitChassis Parts Mechanical Parts and DisassemblyVR Unit Transistors and FETs Semiconductor InformationFront Unit Main Unit Board LayoutsBottom View Jack Unit RF Unit Block DiagramFront Unit Voltage DiagramsRF Unit BC-160 SectionPage 32, Kamiminami, Hirano-ku, Osaka 547-0003, Japan
Top Page Image Contents