Icom IC-M2A instruction manual Installing batteries Battery case, Charging connections

Page 24

(Not supplied with some versions)

7 BATTERY CHARGING

ïCharging connections

qAttach the BC-150 to a ﬂat surface, such as desk or cabin, etc., if

desired.

wConnect the AC adapter (BC-147A/E or BM-95V) as shown below. e Insert the battery pack with/without the transceiver into the

charger.

•The charge indicator lights green.

rCharge the battery pack approx. 8 hours, depending on the re- maining power condition.

CAUTION: DO NOT charge BP-224 more than 12 hours. Otherwise, BP-224 will be damaged. BP-224 must be charged for 8–12 hours only.

IC-M2A

BP-224

Charge indicator

Lights green when

BP-224 (with/without

IC-M2A) is inserted.

Supplied screws

	AC adapter
	(BC-147A/E	BC-150
	or BM-95V)	BC-150
	or BM-95V)

■Installing batteries in the

battery case

When using a battery case attached to the transceiver, install 6 ⋅ AA(R6) size alkaline batteries as illustrated below.

qRemove the battery case from the transceiver. w Install 6 ⋅ AA(R6) size alkaline batteries.

•Be sure to observe the correct polarity.

CAUTION:

•When installing batteries, make sure they are all the same brand, type and capacity. Also, do not mix new and old batteries together.

•Keep battery contacts clean. It’s a good idea to clean bat- tery terminals once a week.

18

Image 24

Contents IM2A Safety Training Information Clean the Transceiver Thoroughly with Fresh Case of EmergencyWord Definition Rwarning For U.S.A. only Table of Contents Operating Rules PrioritiesPrivacy Radio licenses0PTT Switch PTT Panel DescriptionFront, top and side panels Battery Case Release Screw To remove the battery case To attach the battery caseFunction display 1BATTERY Indicator 5CHANNEL Group Indicator p6TRANSMIT Power Indicator 0SUB Channel ReadoutBasic Operation Channel selectionChannel Channel 9 Call channelAdjusting the squelch level Lock functionWeather channels Rotate OFF/VOL clockwise to turn power on Push H/L to select the output power if necessaryReceiving and transmitting Push Y/Z to select the desired channelCall channel programming Automatic backlightingDUALWATCH/TRI-WATCH DescriptionOperation DUALWATCH/TRI-WATCH SimulationScan Operation Scan typesPriority Scan Normal ScanSetting tag channels Starting a scanSET Mode SET mode programmingSET mode items Beep tone bPScan resume timer St Priority scan function PrAuto scan function AS Monitor action selection SqAuto power save function PS Contrast of the LCD can be adjusted from 4 levelsAutomatic backlighting bL LCD contrast selection LCBattery voltage indicator bt Meter/RF meter indicator SrFunction Indication Switch Battery Charging Battery chargingBattery cautions Recycling information U.S.A. onlyInstalling batteries Battery case Charging connectionsOptional battery chargers Rapid charging with the BC-119N+AD-103Rapid charging with the BC-121N+AD-103 Supplied Accessories and Attachments Supplied accessoriesFlexible antenna HandstrapSwivel belt clip To attachTo remove Troubleshooting Problem Possible Cause SolutionLow power only Channel ListSpecifications and Options SpeciﬁcationsOptions Kamiminami, Hirano-ku, Osaka 547-0003 Japan