Icom IC-M2A Battery Case Release Screw To remove the battery case, To attach the battery case

Page 9

ïBATTERY CASE RELEASE SCREW To remove the battery case:

Turn the screw counterclockwise, then pull the battery pack in the direction of the arrow as shown below.

To attach the battery case:

Insert the battery case in the IC-M2A completely, then turn the screw clockwise.

NOTE: When removing or attaching the battery case, use a coin or flat-head screwdriver to loosen or tighten the bottom screw.

Screw position

when removing battery

LOCK

OPEN

Screw position

when attaching battery

LOCK

OPEN

PANEL DESCRIPTION 2

CAUTION!:

When attaching or releasing a battery pack, make sure the rubber seal is set in the groove of the battery pack/case correctly. If the seal is not neatly in the groove it may be damaged when attaching the battery pack/case.

If the seal is damaged, waterproofing is not guaranteed.

NOTE:

When attaching a battery pack/case, make sure dust etc. does not adhere to the rubber seal. If dust etc. is on the seal when attaching a battery pack/case, the water resistant may be reduced.

Make sure both the rubber seal (purple) is set to the groove correctly and dust etc. does not adhere to it.

Correct position

Incorrect position

 

Rubber seal

 

Groove

Battery pack/case

Battery pack/case

3

Image 9
Contents IM2A Safety Training Information Case of Emergency Clean the Transceiver Thoroughly with FreshWord Definition Rwarning For U.S.A. only Table of Contents Priorities Operating RulesPrivacy Radio licenses0PTT Switch PTT Panel DescriptionFront, top and side panels To attach the battery case Battery Case Release Screw To remove the battery caseFunction display 5CHANNEL Group Indicator p 1BATTERY Indicator6TRANSMIT Power Indicator 0SUB Channel ReadoutChannel selection Basic OperationChannel Channel 9 Call channelAdjusting the squelch level Lock functionWeather channels Push H/L to select the output power if necessary Rotate OFF/VOL clockwise to turn power onReceiving and transmitting Push Y/Z to select the desired channelAutomatic backlighting Call channel programmingDescription DUALWATCH/TRI-WATCHOperation DUALWATCH/TRI-WATCH SimulationScan types Scan OperationPriority Scan Normal ScanStarting a scan Setting tag channelsSET mode programming SET ModeSET mode items Beep tone bPPriority scan function Pr Scan resume timer StAuto scan function AS Monitor action selection SqContrast of the LCD can be adjusted from 4 levels Auto power save function PSAutomatic backlighting bL LCD contrast selection LCBattery voltage indicator bt Meter/RF meter indicator SrFunction Indication Switch Battery charging Battery ChargingBattery cautions Recycling information U.S.A. onlyCharging connections Installing batteries Battery caseOptional battery chargers Rapid charging with the BC-119N+AD-103Rapid charging with the BC-121N+AD-103 Supplied accessories Supplied Accessories and AttachmentsFlexible antenna HandstrapTo attach Swivel belt clipTo remove Problem Possible Cause Solution TroubleshootingChannel List Low power onlySpecifications and Options SpecificationsOptions Kamiminami, Hirano-ku, Osaka 547-0003 Japan