9 TROUBLESHOOTING
If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center.
PROBLEM | POSSIBLE CAUSE |
|
|
|
| SOLUTION | REF. |
|
|
|
|
|
|
| |
No power comes on. | • The battery is exhausted. | • Recharge the battery pack. | pgs. 12, | ||||
| • Bad connection to the battery pack. | • Check the connection to the | 14 | ||||
|
| transceiver. |
| ||||
|
|
|
|
|
|
| |
No sound comes from the | • Squelch level is too deep. | • Set squelch to the threshold point. | pgs. 5, 6 | ||||
speaker. | • Volume level is too low. | • Set [VOL] to a suitable level. |
| ||||
|
|
|
|
|
|
| |
Transmitting impossible. | • Some channels are receive only. | • Change channels. | p. 5 | ||||
| • The battery is exhausted. | • Recharge the battery pack. | p. 12 | ||||
|
|
|
|
|
|
|
|
The displayed channel | • Lock function is activated. | • Push |
|
|
| for 2 sec. to cancel the | p. 6 |
|
|
| |||||
|
|
| |||||
cannot be selected. |
| function. |
|
| |||
|
|
|
|
|
|
| |
Scan does not start. | • All memory channels are programmed | • Cancel the lockout settings of | p. 9 | ||||
| as lockout channels. | desired channels. |
| ||||
|
|
|
|
|
|
|
|
No beep sounds.
•Beep tones turned OFF.
•Turn the beep tone ON in set mode.
p. 11
16