pay particular attention to the environment requirements for UPS battery in next chapter “USING THE TOUCH POS”.
BASE MOUNT UPGRADE KIT
On rear edge of the stand assembly for desktop mount application, there is a rear connect cover. Either a 2nd LCD display panel option LM- 6201 or a VFD customer display option
can be installed here after removing this cover. Please note that for
6217U, there could be much more restrictions to the tilt angle range for the main unit due to larger dimensions of the LCD panel if base mount upgrade kit mounted. Investigation for the acceptability of such kind of restrictions must be taken before decision to install a base mount upgrade kit to these models.
To remove the rear connect cover in slim base please refer to the inside view of the base unit at right and use a flat
head screwdriver to pick the plastic hook plate of the
rear connect cover from inside behind the UPS battery.
The rear connect cover of universal base can be removed by pushing the plastic hook plate of it from inside as marked by white arrow in the right picture. However, this picture is an
12” 2nd LCD Panel Or Customer Display
Fit the joint base of
opening. Please route the interface cable through the normal cable exit (under the joint base) as in the 2 pictures. Fit 2 screws through washers to hold the
joint tight. For low profile customer display
installation procedure is same. Remember to enable the +5 V DC supply in the COM port of the main unit for
15” 2nd LCD Panel
A bracket kit including a steel interface bracket will be provided with the 15” 2nd LCD panel
Part 10