arrowed in same picture. Gently arrange the excessive length of this cable back in the hole and
DESKTOP MOUNTINGKS6115:258~355
Matching Pegs Matching Holes
Round Part
Slot Part
Match the matching pegs on the back of the main unit against the matching holes on the stand assembly. First aim the matching pegs toward the upper round part of the hole and make sure that all pegs are inside the holes. Then slide the main unit down to move the pegs into the lower slot part of the holes till it clicks. Note that all the cables come out of the stand from the lower edge and won’t get trapped by this mounting operation. If later on you want to remove the main unit from the stand, you’ll have to press down the lock/release button on back of the stand at the time lifting the main unit.
For desk top/counter application, the total dimension of slim base KS- 6215 occupies a space of 378 mm wide, 304 mm deep and 274 to 364 mm high per main unit tilt angle. The universal base
mmwide, 342 to 304 mm deep and 290 to 400 mm high. The universal base
WALL MOUNTING
The wall mount model is delivered without any base but with a wall mount kit. Please follow the installation guide that comes with the wall mount bracket to fix the wall mount bracket on wall and then hang the main unit with the matching pegs into the matching holes on wall mount bracket.
Please note that since there is no base for the wall mount model there can be no base installed device nor base mount kit. Consequently, the mass storage device for
Part 12