Standard Horizon HX460S owner manual Using the NC-72 Battery Charger, FBA-23 Battery Case

5.3USING THE NC-72 BATTERY CHARGER

1. Turn the transceiver off.

2. Insert the miniature plug on the end of the NC-72Battery Charger cable into the EXT DC jack of the transceiver.

3. Plug the NC-72into a 120 VAC wall out-

	let.
4.	The indicator will glow red, indicating that
	charging has begun.
5.	When charging is completed, the red
	indicator will change to green. Remove
	the plug from the EXT DC jack when
	charging has been accomplished.
6.	Replace the rubber gasket in its place
	to protect the inside of the transceiver
	from the water.
	We do not keep the water-proof while
		Figure 7
	opening the gasket.

5.4 FBA-23 BATTERY CASE

FBA-23is a battery case that holds two alkaline batteries and is used with the HX460S transceiver. Alkaline batteries can be used for transmission in an emergency, but power output will only be 0.9 W, and battery life will be short.

1. Slide the batteries into the FBA-23with the Nega- tive [–] side of the batteries touching the spring connections inside the FBA-23.

2. Insert the FBA-23into the battery compartment on the back of the transceiver, then close the Battery Pack Latch until it locks in place with a “click.”

Note: The battery indicator on the transceiver is only
applicable to the FNB-V75LIrechargeable battery. Dis-
regard this indication when using alkaline batteries.	Figure 8

HX460S Page 23