5.7 SCAN
This transceiver provides a special “Scanning Memory Bank” which allows you to designate certain channels for inclusion in a “loop” which will be scanned at high speed. If an incoming signal is detected on one of the chan- nels in the scanning loop, the radio will pause on that channel, allowing you to listen to the incoming transmission.
1.Select the desired channel to be included in the scanning loop using the [] or [] key.
2. Press the MEM key to store the channel into the transceiver’s scanning memory. “MEM” will be dis- played on the LCD.
3.Repeat steps 1 and 2 for all the channels to be scanned.
4.To delete a channel from the transceiver’s scan memory, press the MEM key again while the memorized channel is displayed. “MEM” will disap- pear from the display.
5.All channels programmed remain in the transceiver’s scan memory even if the power is turned off.
6.Press the SQL key, then press the [] or [] key until background noise is eliminated.
7.To start scanning, press the SCAN key. The scan proceeds from the lowest to the highest programmed channel number and stops on chan- nels when a transmission is received. Scanning will resume when the squelch closes after the incoming signal disappears at the end of the transmission.
8.To stop the scan, press the SCAN, 16/9, or WX key.
Page 20 |
| HX370S |
|