Pioneer PDR-609 Care and maintenance, Putting the batteries in the remote control

Putting the batteries in the remote control

1 Before you start

English

•Turn over the remote control, then press and slide the battery compartment cover off.

•Put in the batteries supplied, taking care to match the plus and minus ends of each battery with the markings inside the compartment.

•Slide the cover back on, and your remote is ready for use.

Caution!

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Don’t mix new and old batteries together

•Don’t use different kinds of battery together—although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that isn’t going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public institution’s rules that apply in your country or area.

Avoiding condensation problems

Condensation may form inside the player if it is brought into a warm room from outside, or if the temperature of the room rises quickly. Although the condensation won’t damage the player, it may temporarily impair its performance. For this reason you should leave it to adjust to the warmer tempera- ture for about an hour before switching on and using.

Care and maintenance

Cleaning external surfaces

To clean the compact disc recorder, wipe with a soft, dry cloth. For stubborn dirt, wet a soft cloth with a mild detergent solution made by diluting one part detergent to 5 or 6 parts water, wring well, then wipe off the dirt. Use a dry cloth to wipe the surface dry. Do not use volatile liquids such as benzene and thinner which may damage the surfaces.

Moving the unit

If you need to move the unit, first switch it off and unplug from the wall outlet. Never lift or move the unit

during playback or recording—the disc rotates at a

high speed and may be damaged.

Handling discs

When holding CDs of any type, take care not to leave fingerprints, dirt or scratches on the disc surface. Hold the disc by its edge or by the center hole and edge. Damaged or dirty discs can affect playback and/or recording performance. Take care also not to scratch the label side of the disc. Although not as fragile as the recording side, scratches can still result in a disc becoming unusable.

Should a disc become marked with fingerprints, dust, etc., clean using a soft, dry cloth, wiping the disc lightly from the center to the outside edge. If necessary, use a cloth soaked in alcohol, or a commercially available CD cleaning kit to clean a disc more thoroughly. Never use benzine, thinner or other cleaning agents, including products designed for cleaning vinyl records.

Wipe lightly from the	DonÕt wipe the disc
center of the disc	surface using circular
using straight strokes.	strokes.

Storing optical cable

When storing optical cable, coil loosly as	more
shown at right. The cable may be	+ than =
	5-14/16 in
damaged if bent around sharp corners.
	(15 cm)

7

En