removed prior to re-arming.
5)Check the housing to be sure it is clear and dry. If necessary, rinse the inflator with fresh water to remove dirt and salt. Let dry before going to step 6.
Figure 10 | MD3083 and MD3084 Automatic Inflator |
|
| CO2 |
| Cylinder |
| Step 2 |
Cylinder / |
|
Bayonet | Sensor Ring |
Assembly | Step 9 |
Step 2 | Bayonet |
| |
| Tab |
| Step 9 |
| |
| Step 9 |
| Pins |
| Lever |
| Step 10 |
Cap
Step 3
Yellow Bobbin (white side up) Step 4
HOUSING**
Step 4
Housing
Shoulder
Step 8
Service
Indicator
Step 11
Pull-Tab
6)Inspect the bobbin. If the bobbin has been fired or damaged, replace it! Ensure the new bobbin is valid, it must have been purchased within the last three (3) years. If the bobbin purchase date is
11 | Inflatable PFD Owner’s Manual |