Eagle Electronics 2000 manual Displaying a Saved Trail

Page 119

2.Press ↓ to the active Trail NameENT.

3.Press → then ↓ to ACTIVEENT. This unchecks the Active option.

4.To return to the previous page, press EXITEXITEXITEXIT. After you leave the Edit Trail menu, you will notice a new trail was started with a new sequential number. In the example below, the new trail is number 15, showing zero points. Note Trail 14 is inactive, but is still visible on the map.

A new trail, Trail 15, is created when Trail 14 is made inactive. Any new travel will be recorded in this trail, which is active and visible.

Trails do not need to be visible in order to be active.

You can save and recall up to 10 different plot trails, which can be copied to your MMC for archiving or transferred to your MapCreate software.

Tip:

Another quick way to stop recording one trail and begin a new one is to use the New Trail command: Press MENUMENU↓ to MY TRAILSENTENT.

Caution:

You also have the option of completely turning off trail recording, under the trail Options command. If the Update Active Trail option is left off, it will cancel the automatic trail creation feature.

Displaying a Saved Trail

The active trail is automatically displayed on the map (the "Visible" option) with the factory default settings. You can selectively turn the trail display off and on for any saved or active trail. In the Saved Trails List, visible trails have a check mark in front of the trail name.

111

Image 119

Contents FishStrike2000 & SeaChamp2000 CDF Copyright 2005 LEI-Eagle All rights reserved Table of Contents Sonar Troubleshooting Basic GPS Operations Sonar Options & Other FeaturesAdvanced GPS Operations 117 System & GPS Setup Options 129 Sec Supplemental Material Datums 179 165Page Section Read Me First Page Sonar GeneralCurrent drain Back-up memoryGraph recording Audible alarmsPosition updates Symbols for waypoints Event markerHow Your GPS Works How Your Sonar WorksPage Introduction to GPS and Waas Page How to use this manual typographical conventions Instructions = Menu Sequences Menu CommandsArrow Keys KeyboardPreparations Transducer InstallationSelecting a Transducer Location Recommended Tools and suppliesDeadrise less than Strakes Pad How low should you go? Assembling the bracket Transom Transducer Assembly And MountingShoot-thru-hull vs. Transom Mounting Dot Aligning the transducer on the transom Assembling the transducer Attaching transducer to transom Drilling mounting holesBottom Hull Flat-bottom hull Deep-vee hull Trolling Motor Bracket Installation single-frequency only Transducer Orientation and Fish Arches Epoxy the transducer to a solid portion of the hull Transducer location High speed Trolling speed Shoot-thru-hull Installation Epoxy transducer to hull Speed/Temperature Sensors GPS Optional Speed Sensor InstallationGood location Nmea 0183 Cable Connections GPS Antenna/Receiver Module InstallationNmea Wiring Power Connections Page Mounting the Unit Bracket or In-Dash Bracket InstallationCable hole Screw mounting hole Front In-Dash Installation MMC or SD Memory Card Installation MMC and MapCreate Other AccessoriesPage Keyboard Section Basic Sonar OperationPower/lights on and off Main Menu Satellite Status PagesMap NavigationSonar Sonar Page showing full sonar chart mode Page FishStrike 2000 and SeaChamp 2000C DF Sonar Quick Reference Sonar Operations To adjust sensitivity Other Free Training Aids Fish Symbols vs. Full Sonar ChartPage Page To change the ASP level ASP Advanced Signal ProcessingDepth Alarms AlarmsFish Alarm Zone AlarmCalibrate Speed Chart SpeedColorLine To adjust the ColorLine level Depth Cursor Cursor line Depth box Depth Range AutomaticFasTrack Depth Range ManualTo turn the Fish I.D. feature on Fish I.D. Fish Symbols & DepthsTo turn on FishTrack FishTrackDual-Frequency Transducers only, SeaChamp 2000C DF FrequencyHyperScroll Log Sonar Chart DataTo change the frequency setting to 50 kHz To change the frequency setting to 200 kHzOverlay Data To record or log chart dataNoise Rejection To remove overlaid data To overlay information on your screenTo move overlaid data Overlay Data Style Ping Speed & HyperScroll To turn off HyperScroll To change Ping SpeedSet Keel Offset Reset OptionsReset Water Distance Page Automatic Sensitivity To adjust sensitivity in auto modeSensitivity & Auto Sensitivity To change the chart mode Sonar Chart ModeTo adjust sensitivity in manual mode Full Sonar Chart Sonar Page & Sonar Chart Display OptionsSplit Frequency Sonar Chart Dual-Frequency Transducers only Split Zoom Sonar ChartDigital Data Display To change information displayed in a data box Customize Page DisplaysMap With Sonar Split Screen Sonar SimulatorOnentexit Surface Clarity Stop ChartZoom & Zoom Bar To adjust the Surface Clarity levelZoom Pan Unit freezes, locks up, or operates erratically Unit operates only in demo modeUnit wont turn on No fish arches when the Fish I.D. feature is off Noise Page Section Basic GPS Operations Power/lights on and off Main Menu Pages Menu showing some Map display options Satellite Status Position Map Background map vs. MapCreate map content POI Page Two Maps page with one window stacked on top of the other GPS Quick Reference Moving Around the Map Zoom & Cursor Arrow Keys Find Your Current PositionSearching Selecting Any Map Item with the CursorPage To create and save a Waypoint Set a WaypointCreate Waypoint on Map Navigate To a Waypoint Navigate Back to MOB Waypoint Set Man Overboard MOB WaypointNavigate to Cursor Position on Map Navigate to a Point of Interest To Save a Trail Creating and Saving a TrailDisplaying a Saved Trail Navigate a Trail forward Navigating TrailsTo turn on trail display Visual TrailingPage Custom Maps Transfer Custom Maps and GPS Data FilesGPS Data files Exitexitexit Cancel NavigationIcons Find Distance from Current PositionFind Distance from Point to Point Delete an Icon Create Icon on MapCreate Icon at Current Position Navigate to an Icon RoutesCreate and Save a Route 121 Edit a Route Delete a RouteNavigate a Route Edit a Trail Name TrailsNavigate a Route in Reverse Delete a TrailEdit a Trail Pattern Edit a Trail ColorWaypoints UtilitiesSet a Waypoint by Average Position Selecting a WaypointSet a Waypoint by Projecting a Position Section System & GPS Setup Options Check MMC Files and Storage Space Auto Satellite SearchConfigure Nmea Communications Port ConfigurationCoordinate System Selection Map Fix To set up Loran TDTo configure a map fix Customize Page Displays To change the information displayed in a data box GPS SimulatorSimulating Trail or Route Navigation To get to the GPS SimulatorMap Auto Zoom Hide GPS FeaturesInitialize GPS Draw Map Boundaries Map DataEarth Map Detail Pop-up Map InfoTrackline Extension Presentation ModeSafety Contour Fill Water with WhiteMap Datum Selection Map Orientation Map Detail Category SelectionDisplay a Navionics chart Navionics ChartsPort Information To view Port Services informationTidal Current Information To view Tidal Current information To view tide information Tide InformationCursor line Pop-up name box Tide Station icon Overlay Data with the Navigation category expanded Entent To move overlaid data Overlay Data Style Gauge Setup menu Ticks menu left with Threshold menu right Pop-up Help Screen Contrast and Brightness Set Language Set Local Time Software Version Information Show Waas AlarmSounds and Alarm Sound Styles Track Smoothing Delete All Trails Update Trail OptionTrail Options Delete Trail Trail Visible/Invisible and Other Trail Options Units of MeasureNew Trail System Setup Menu left Units of Measure Menu right 164 Find Addresses Sec SearchingFind Address Menu Tip Find Interstate Highway Exits Find Any Item Selected by Map CursorFind Highway Exits command left and Find Exit menu right Find Exit menu with an exit selected from the list Find Map Places or Points of Interest POI Find by Nearest left with POI list right Find a Street Find Streets or IntersectionsPage Find an Intersection Page Find Waypoints Page Sec Supplemental Material Datums Used by This Unit 180 181 182 FCC Compliance 184 Eagle Databases License Agreement Databases Limited Warranty Eagle Electronics Full ONE-YEAR Warranty Not toll-free How to Obtain Service…189 190 Accessory Ordering Information for all countries Visit our web site