Simulator Operation, Feature Memory

USING THE 105SX

SIMULATOR OPERATION

The 105SX contains a simulator that allows you to use the unit as if you are on the water. The simulator is invaluable for learning how to operate the 105SX.

There are two ways to start the simulator. If the unit is powered off, press and hold the POWER button for approximately three seconds until you hear a continuous chirp.

The simulator can also be started by

selecting the Simulator option on the start- up screen after you power-up the unit. When this screen is shown, simply press the

DOWN ARROW until “Simulator” is highlighted. When the screen times out, the unit will be in simulator mode.

When in simulator operation, the 105SX responds to control inputs as if it is in actual operation, so feel free to experiment, or to customize the unit for your particular operation.

To exit Simulator mode, power the unit off.

When in simulator mode, the word “simulator” will flash on and off in the top center part of the display.

FEATURE MEMORY

If your 105SX is installed with a transducer connected, any changes you make to the set-up while in Simulator are retained in the unit’s memory. This allows you to use simulator to experiment with the various set-up options, and retain your selected settings for normal operation.