Magnadyne MRC-2U installation manual Keep Hold Flashes 2 Times, Release Button LED Off

Learning an Additional Aquavibe Marine Remote Controller Code

The Aquavibe Marine Remote Controller is already pre-programmed to the receiver. No programming is necessary. If you want to program additional Aquavibe Marine Remote Controllers follow the instructions below.

Note: This receiver will only retain the 4 Marine Remote Controller codes. If the receiver’s memory is exceeded, the receiver will start deleting transmitters codes from memory in chronological order.

Step 1 Step 2

Hold Solid LED

Turn on the power to the receiver’s housing.

Press and hold the button on the receiver until the LED turns on solid.

Step 3

Keep Hold

Flashes 2 Times

While still pressing the button on the receiver, press and release the SRC button on the remote until the LED on the receiver flashes 2 times, indicating the code is learned.

Step 4

Release Button

LED Off

Release the receiver’s button and the LED will turn off. Repeat Steps 2-4 to program additional remotes. Note: Up to 4 remotes can be programmed.

10