Magnadyne MRC-2U Seconds Flashes 3 Times, IR Input Sensor Radio Remote LED on Solid

Automatic Code Learning (continued)

Step 5 Step 6

or

5 Times

To exit programming push the switch on/off 5 times or wait 15 seconds and the system will automatical- ly exit the “Automatic Code Learning” mode.

Try each button on the remote to make sure each button has been learned properly. If the remote does not function properly proceed to “Manual Code Learning” section below.

Manual Code Learning

Step 1 Step 2

7 Seconds

Flashes 3 Times

Turn on the power to the receiver’s housing.

Press and hold the button on the receiver for 7 seconds. The LED on the receiver will flash 3 times and then turn off. Release the switch. You are now in “Manual Code Learning” mode

Step 3

IR Input

Sensor

Radio Remote

LED on Solid

Within 15 seconds, aim the radio remote at the IR	The LED will light up solid when the code has
input sensor and push the “VOLUME UP” button	been copied.
on the radio remote.

8