Settings
Your Detector
User Settings
•
IntelliShield City Mode Default
City Mode Default makes three levels of Audio Alert suppression available when you toggle from Highway to City mode (see page 8). The factory setting is City X.
City X sounds a single beep when an x band signal is first detected. The alert then sounds when signal strength reaches level 3.
City X+K combines the City X mode with prevention of K band audio alerts until the signal strength reaches level 2.
City X Beep Off blocks all X band audio alerts until the signal strength reaches level 3.
IntelliMute Mode
IntelliMute is a unique feature that allows you to avoid alerts you don’t need to hear because you are stopped or moving slowly. By sensing the “revs” (RPMs) of your engine, IntelliMute knows when you are at low speed and automatically mutes alerts (except for strobe signals from emergency vehicles). It works with all City and Auto Mute modes.
Before IntelliMute will work, you must set an activation point for your engine’s revs (see page 15). Whenever the revs are below that point, IntelliMute will begin muting. The activation point will be stored in memory and recalled each time the power is turned on. The factory setting is IntelliMute off.
An IntelliMute icon will appear in the display when IntelliMute is on and activation is set. Whenever engine revs are below the activation point, the arrow points down. When revs are above the activation point the arrow points up.
Above | Below | |
Activation Point | Activation Point | |
|
|
|
If, for any reason, the unit stops sensing your engine’s revs, IntelliMute will indicate an error and automatically turn off.
14 English
Settings
Your Detector
NOTES
IntelliMute may not work with some vehicles because it cannot sense the engine’s revs. In such cases, you can reduce unwanted audio alerts by using Auto Mute and City mode when appropriate.
NOTES
The rev point must be reset if you use your detector in a different vehicle.
NOTES
When initially choosing your IntelliMute activation point, a setting of approximately 300 to 600 RPMs above idle is recommended. You can reset the activation point at any time to fit your individual preferences and driving style.
CAUTION
Do not attempt to set the rev point while driving. Your vehicle should be parked and idling to avoid a collision during the process.
Set IntelliMute
After the detector is installed in your vehicle and the unit is turned on, advance through the User Settings Programming to the Set IntelliMute setup screen where the activation point can be set.
Setting the activation point progresses from the setup screen shown
on the User Programming Menu Guide (see page 34). From that screen:
1.Press the Mutebutton to begin the setting process.
2.Press and hold the vehicle accelerator at the desired engine RPMs.
3.Press the Mutebutton to complete the setting process.
The system will store the engine RPM setting and provide a completion message on the display as well as a tone or voice message.
NOTE
If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 30 seconds of beginning the setup, IntelliMute will indicate an error. If you do not try again within five seconds, it will automatically turn off. The unit will provide corresponding messages for these conditions.
Once an activation point has been set, you can easily change it by going directly to Set IntelliMute in User Settings Programming and repeating the
Nothing Comes Close to a Cobra® 15