Cobra Electronics XRS 9940 operating instructions Windshield Mounting, Dashboard Mounting

Installation

Your Detector

Windshield Mounting

1.Attach the rubber

cups to the bracket.

2.Make sure the rubber cups and your windshield are clean.

3.Push the bracket firmly

onto the windshield.

4. Attach the detector to the bracket. Check that the unit is parallel to the road's surface.

5.To adjust the angle if

necessary, gently push or pull on the bracket to bend it. DO NOT use the detector to bend the bracket.

6.Plug the power cord into the detector.

7. Plug the cigarette lighter adapter on the power cord into your vehicle’s cigarette lighter.

8.You can temporarily remove the detector whenever you wish by depressing the bracket release button and sliding it off the bracket.

4English

Installation

Your Detector

Dashboard Mounting

1.Place the detector on the dashboard to find a location where the unit has a clear view of the road and is parallel to the road's surface. The angle CANNOT be adjusted after mounting.

2. Remove the paper backing from one side of the hook- and-loop fastener.

3. Attach the pad to the dashboard at your chosen location and remove the other paper backing.

4.Attach the detector to the hook-and-loop fastener. You can remove and reattach the unit as often as you like.

5.Plug the power cord into the detector.

6. Plug the cigarette lighter adapter on the power cord into your vehicle’s cigarette lighter.

Nothing Comes Close to a Cobra® 5