Furuno NX-300 manual Other Functions, Demo Mode, View Mode, All Clear

4. OTHER FUNCTIONS

4.1 DEMO Mode

The DEMO mode provides simulated operation of this unit. Connection of antenna is not necessary. You may select stations and messages manually or automatically and demo messages are received. All controls are operative.

Note: Turning on the DEMO mode erases all messages.

Press the [PWR] key while pressing to turn the power on. “SET DEMO MODE!” appears momentarily. “DEMO” appears at the top of the screen when the DEMO mode is active.

DEMO mark

Figure 4-1 Message display

To escape the DEMO mode, press the [PWR] key while pressing . “RESET DEMO MODE!” appears momentarily.

4.2 VIEW Mode

The NX-300 ordinarily displays messages in their entirety. The VIEW mode, however displays messages character by character.

Press the [PWR] key while pressing to turn the power on. “SET VIEW MODE!” appears momentarily. “VIEW” is displayed at the upper left corner of the display.

To quit the VIEW mode,: repeat above procedure. “RESET VIEW MODE!” appears.

4.3 All Clear

This function deletes all messages and restores default settings. When the NX-300 is first installed, you should clear all data.

Press the [PWR] key while pressing to turn the power on. “RESET BACKUP DATA!” appears momentarily while data is being cleared. Then, all default settings are restored.

4-1