Furuno NX-300 manual Selecting Language, Displaying Messages

2.8 Selecting Language

You can select language displayed on the NX-300. Languages are English, French, German, Italian, Spanish, Dutch, Danish, and Portuguese.

1.	Press the [MENU] key to open the main menu.
2.	Press to select LANGUGE.

3.Press the [ENT] key. The following menu appears. (ENG: English, FRA: French, GER:

German, ITA: Italian, SPA: Spanish, DUT: Dutch, DEN: Danish, POR: Portuguese)

Figure 2-20 LANGUAGE menu

4.Use the Omnipad to select language desired.

5.Press the [ENT] key to register your selection and press the [MENU] key to close the menu.

2.9 Displaying Messages

The NX-300 automatically saves and stores up to 132 received messages (However, the memory capacity is limited to 28,000 characters). If memory of the NX-300 is full, messages are deleted on order of time.

1.Press the [DISP] key to show the received messages log. Messages (numbers) are arranged in the order received from latest to earliest, Left to right.

The latest message

For A, B or L type message

Unread message D type message

	Figure 2-21 Received messages log
2.	Operate the Omnipad to select the message to display. If more than 15 messages are
	saved, the scroll bar appears at the rigth side of the display. Press or to scroll the
	display.
3.	Press the [ENT] key to display the message selected.

Note: If you want to see the received frequency (518 kHz or 490 kHz) also, change the window mode as shown on page 4-2.

2-9