Furuno FR-8051 manual Own Ship Speed, Turning on a function, Automatic speed input

Table 1-1 Eight available target objectives

Objective	Description
S1	Short range navigation
(Short range 1)	(within 1.5 nm); for example,
	in harbor area.
S2	Short range navigation within
(Short range 2)	3 nm, e.g., harbor approach.
S & M	Coastal navigation on ranges
(Short and	within 12 nm.
Medium ranges)
L-ES	To enhance target on 1.5 to 6
(Long range-	nm range by using Echo
Echo Stretch)	Stretch.
L-AC	To suppress sea clutter on 3
(Long range-	nm range and higher ranges.
anti-clutter)
ES	To magnify target echoes on
(Echo Stretch)	1.5 nm range and higher
	ranges.
B1 (Buoy 1)	To detect small targets (nav
	buoys, small vessels, floats,
	etc.) on ranges within 1.5 nm.
B2 (Buoy 2)	To detect small targets on
	ranges greater than 1.5 nm.

Procedure

1)Press the FUNCTION key to display function number to program (F1, F2, or F3).

2)Press the MENU key and select the FUNC menu.

3)Press the ENTER/SELECT key.

FUNC FUNC SEL (S1, S2, S&M, L-ES, L-AC, ES, B1, B2)

ECHO AVG (OFF, 1, 2, 3)

INTRF (OFF, 1, 2, 3)

STRETCH (OFF, 1, 2)

A/C AUTO (OFF, ON)

N REJ (OFF, ON)

P/L SET

0.75~1.5NM: SP, M1P

3NM: SP, M1P, M2P

6NM: M1P, M2P, LP

12~24NM: M2P, LP

Figure 1-19 FUNC menu

5)Select FUNC SEL and press the ENTER/SE- LECT key.

6)Select target objective desired and press the ENTER/SELECT key.

7)Press the MENU key.

Note: Each target objective defines a combina- tion of several radar settings for achieving opti- mum setup for that particular objective. Therefore, adjustment of radar settings through the FUNC menu is not necessary. If you acci- dentally change the settings, default settings can be restored by reselecting the target objective.

Turning on a function

Press the FUNCTION key to display function number desired (at bottom left corner on the dis- play.)

Note: When the main menu displays FUNC KEY*, this means no function is active and the FUNCTION key is inoperative. To select a func- tion, erase the menu and press the FUNCTION key.

1.23 Own Ship Speed

Ship’s speed can be entered manually or auto- matically (by speed log or radionav equipment). Own ship's speed is required for TM and display of vectors, E-plot, etc. The True Motion display works on a ship speed entered manually or auto- matically.

Automatic speed input

1)Press the MENU key and select the INITIAL menu.

2)Press the ENTER/SELECT key.

3)Select SPD MODE and press the ENTER/ SELECT key.

4)Select LOG or NAV and press the ENTER/ SELECT key.

6) Press the MENU key.

Note: If no speed is input for 3 minutes at below

0.1knots, the radar regards this a log failure and displays SYSTEM FAIL LOG.

1 – 17