Furuno FR-7062, FR-7252, FR-7112 manual Activating the Auto Plotter, ARP menu

6.3 Activating the Auto Plotter

To activate the ARP-10, follow the steps shown below.

1.Adjust the GAIN, A/C SEA and A/C RAIN controls for proper radar picture.

2.Press the [MENU] key to open the main menu.

3.Operate the trackball to select “ARP-10 MENU”.

4.Press the [ACQ/ENTER] key. The menu shown in Figure 6-1 appears.

[ ARP MENU ] Select item by T-ball and press ENTER key.

1 . Display		Off		On
2	. All Cancel
3	. Vector Ref	Rel		True
4	. Vector Length			30sec	1min
		3min	6min	15min
					30min
5	. History	Off	15sec	30sec	1min
		2min	3min	6min
6	. CPA Set		0.5nm	1nm	2nm
		Off
		3nm	5nm	6nm
7	. TCPA Set		1min	2min	3min
		30sec
		4min	5min	6min	12min
8	. Auto ACQ			On
		Off

5.	Operate the trackball to select the menu item	Figure 6-1 ARP menu
	“1. Display”.
6.	Operate the trackball to select “On”.
7.	Press the [ACQ/ENTER] key.
8.	Press the [MENU] key to close the menu.

Target is being tracked but is not selected for data readout

	8 NM
Target Full	2 AUTO TARGET
	SP FULL
Mark	HU RM

Lost Target

HDG 234.5°

TRAIL AUTO

25:38 30min

G (OUT)

ZOOM

ES1

Threatening target

Target selected for data reading (large square)

Auto

Acquisition

Area

A/C
AUTO				VRM
EBL/PI
345.6°R	13.5°R	0.142NM	0.048NM
23.0°R			0.100NM
	BEARING 42.5°T		COURSE 287.8°T
TRUE VECTOR	RANGE	5.36 NM	SPEED	12.5 KT
15 MIN	CPA	2 NM	TCPA	12:35

ARPA Data Area

Figure 6-2 ARP display

6-3