3.Use the flat washers and spring washers removed earlier and appropriate hex bolts (see the illustration below) to fasten the antenna unit to the platform. The torque should be between
Antenna base |
assy. |
*1 |
Flat |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |||
washer |
|
|
|
|
| Platform | |||||
|
| ||||||||||
|
|
|
|
|
|
|
|
|
| ||
Spring | Apply silicone | ||||||||||
washer Hex bolt | |||||||||||
|
|
| (M10 x 25 | sealant. | |||||||
|
|
|
|
|
| ||||||
|
|
| or M10 x 20) |
|
|
| |||||
*1: Platform thickness | Bolt to use | ||||||||||
|
|
|
|
|
| ||||||
| 5 mm or less: |
| M10 x 20 | ||||||||
| M10 x 25 | ||||||||||
| over 10 mm: | locally supplied bolts | |||||||||
How to fasten the antenna base to platform
4.Unfasten four screws to open the cover. Remove and discard the packing material inside the radome.
Remove and discard the packing material.
Snap holder
Antenna unit, inside view
3. INSTALLATION
The antenna base is fitted with a snap holder, which may be used to hang the cover after removal. Use the hole next to the screw hole inside the cover to hang it.
a)Unfasten the snap assy. with the string attached at the holder in the antenna base.
b)Unwind the string.
c)Attach the snap to the screw hole on the inside of the cover.
Note: Do not use the snap holder to hang objects other than the cover.
5.Release the cable of the rotation detector from the cable clamp.
6.Unfasten 11 screws to dismount the shield plate.
Cable clamp
Shield plate
Rotation detector
Caution
7.Pass the antenna cable with connector through the gasket and cable clamp, and then tighten the cable gland.
Note: Two gaskets are supplied: one gray, one black. Use the proper gasket according to antenna cable used, referring to the illustration below.
Antenna cable and gasket to use
|
|
| 67 |
|
|
| φ 12 | 49 |
|
|
| φ 11 | ||||||||||
| ||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Use black gasket. | Use gray gasket. | |||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
23