After setup, not all buttons work al expected.
•Try improving the button(s). See chapter 2.2.2.
How do I set up the remote control for combo devices (TV / VCR,TV / DVD, DVD / VCR, etc)? Some combo devices require you to set up two different device selection buttons to control both parts of the combo device. For example,
if you have a TV / DVD combo, you might need to set up the remote control for both TV and DVD to operate your TV / DVD combo.
Operation
The remote control does not wake up anymore.
Battery level too low or battery lifetime came to an end.
•Replace the batteries. See chapter 2.1. After replacing the batteries, test if the remote control still operates your devices. If it does not, you have to set up the remote control again. For this refer to chapter 2.2.
The device I want to operate does not respond at all / does not respond to all of the button commands.
•Check if the buttons you press are available on the original remote control of the device.
•Try improving buttons. See chapter 2.2.2.
Wrong code selected during setup.
•Set up the remote control again for the device. Always test if the device responds, before leaving setup mode.
It may be that the buttons that you are trying to use have a different naming on the original remote control.
•Try out all buttons to find the one(s) you need.
Service and support English
EN 13
P2063WM_17__Manual 13 |