
Ignition Switch | Blower Switch |
|
|
|
| The blower switch activates the blower motor. The primary | |
|
| function of the blower fan is to remove any fumes from the | |
|
| bilge area. The blower also draws fresh air into the engine | |
|
| compartment. | |
|
| Never depend solely on the blower to eliminate dangerous | |
|
| fumes. Before starting the engine, always open the motor | |
|
| box to check if fumes are present. Switch on the blower fan a | |
|
| minimum of four minutes before starting the engine. | |
|
| NOTICE: If the blower fails to operate, reset the circuit | |
|
| breaker. If the blower still does not operate, notify your | |
|
| Supra dealer. | |
Located on the port side of the dashboard, the ignition switch | |||
| |||
has three positions. In the vertical position the ignition is OFF. |
| ||
With the key in, turn the ignition switch one notch to the right | Failure to operate the blower in accordance with the Coast | ||
to check all electrical equipment, including blower, pump, and | |||
Guard Recommendation could result in an explosion. | |||
lights. Turn the ignition all the way to the right to operate the | |||
| |||
starter. |
| ||
NOTE: All electrical equipment should be turned off when |
| ||
the boat is in storage. |
| ||
Horn Switch
| Horn/Whistle Signals |
| |
| One Long Blast: |
| Warning Signal (Coming out of slip) |
| One Short Blast: |
| Pass on my Port Side |
| Two Short Blasts: |
| Pass on my Starboard Side |
| Three Short Blasts: |
| Engines in Reverse |
| Four or More Blasts: |
| Danger Signal |
| 1. OVERTAKING / PASSING: Boat being passed has the |
| |
The Horn Switch is located on the port dash panel near | 2. MEETING |
3. CROSSING: Boat on the right has the | |
the ignition. Sound the horn by depressing the button. | down and permit him to pass. |
|
|
|
|
© 2005 Skier’s Choice, Inc. | SUPRA - 33 |