33. H21SC JENNAKER SYSTEM (option)
FURLER AND BRIDLES
Install furler and bridles onto forward bow tangs. Wind the furler line into the drum.
Install using jib system as guide.
| FURLER CLEAT |
| Install furler cleat onto Cat Cabin next to and left of existing jib furler cleat. |
| HALYARD BLOCK AND CLEAT |
| Install swivel block onto upper mast tang. Install halyard cleat into mast luff track using |
| screws and square nuts. Position in desired location (just above cooler). |
| JENNIKER HALYARD AND SWIVEL |
| Install swivel to head of Jenniker (plastic sleeve may need to be removed). Tie halyard |
FIGURE 49 | |
| to "D" shackle and attach swivel. Run halyard up through halyard block and down mast |
| |
| to cleat. Attach Jenniker tack to furler drum. Hoist Jenniker. |
| SHEETING SYSTEM |
| Install as shown in Fig. 51. Tang fittings |
| are bolted with outboard rear cross bar |
| bolts. Hang Ratchet blocks on tangs. Hook |
| bungee towing tramp lacing. This holds |
| block upright. Tie sheet to Jenniker clew |
| and run around boat as shown in Fig 50. |
| Sheets run outboard of shrouds to inboard |
| of wing through ratchet block across tramp |
| and through opposite ratchet block. Run |
| sheet forward then in front of jib but behind |
| Jenniker system then tie to clew. Trapeze |
| wires must be run inboard of wing. |
| NOTES: |
| Jenniker should not be left furled and or |
| hoisted when not in use. The materials are |
| nylon and do not handle long term UV. |
| Jenniker is designed for down wind sailing. |
| You may broad reach with he Jenniker but |
| undu stress may be caused if attempting to |
| sail on a close reach or in higher winds. |
FIGURE 50
FIGURE 51
26