14.5Attach the left shroud to the top hole of the left shroud adjuster with a 1/4" x 1/2" clevis pin and lock ring. Secure the base of the shroud adjuster to the toggle with a clevis pin and lock ring. Then secure the toggle to the tang on the left hull using a clevis pin and lock ring. (FIGURE 26)
*Note:
SEE UPRIGHT
INSTRUCTIONS
ON FOLLOWING
PAGE
15. TRAPEZE WIRES
15.1Untie and clear the trapeze wires.
15.2Lead the trapeze shock cord through the grommets on the outboard side of the trampoline, then under the trampoline and through the opposite grommets.
15.3Arrange the trapeze wires so they lead outside of the shrouds. Then tie the line to the J & H handle with a bowline knot. After the line is led through the thimble on the end of the trapeze wire, attach the rope lock. Then tie the end of the line to the shock cord with another bowline knot. (FIGURE 27)
FIGURE 26
FIGURE 27
14.6Repeat step 10.9 for the right shroud and shroud adjuster.
13