Baja Marine 342 manual Basic Boat Dimensions and Clearances Metric, Propulsion System

Section 2 • General Boat Arrangement

Basic Boat Dimensions and Clearances (Metric)

Boat Dimensions and Clearances

(Fig. 2.3.1)

10.41m

2.26m

2.01m

342 Performance Specifications Height Dimensions

Overall Length	10.41 m
Beam (width)	2.59 m
Draft (stern drive down)	1.02 cm
Draft (stern drive up in trailering position)	88.9 cm
Dry Weight	3,719.5 kg
Fuel Capacity	700.3 liters
Fuel Capacity (w/ generator)	548.9 liters

From Keel
without Windshield	2.01 m
Keel To Top
Of Windshield	2.26 m
From Waterline
without Windshield	1.50	m
Waterline to Top
of Windshield	1.75	m

4.Propulsion System

Your boat is equipped with a stern drive type propulsion system also known as an inboard- outboard engine. (See Figure 2.2.2) This type of propulsion system has the engine inside the boat secured to the hull's stringers at the rear end of the hull. The stern drive unit, also called the lower unit because it hangs below the hull, is part of the propulsion system that attaches to the outside of the hull or transom. The stern drive unit pivots to steer the boat.

For engine operating instructions, see page 3.4.

2.59m Beam

(FIG. 2.3.2)

5.Propellers

Your Baja® has been equipped with a propeller which our tests have shown to be the best suited for general use under normal conditions and load.

Under no circumstances use a propeller which allows the engine to operate at higher than the maximum RPM for your engine. (See the Engine Operator's Manual.)

342 Performance® 2.3