Section 8 • Required Inspection, Service, &
Maintenance
4.Wiring System
•Check all wiring for proper support.
•Check all wiring insulation for signs of fraying or chafing.
•Check all terminals for corrosion - corroded terminals and connectors should be replaced or thoroughly cleaned.
•Tighten all terminals securely and spray them with light marine preservative oil.
5.Fittings, Hoses and Clamps
•Inspect the entire bilge area for evidence of damage or deterioration. Evidence of deterioration will first appear around hull fittings, hoses and clamps.
•Straighten kinked hoses.
•Replace any hose that does not feel pliable.
•Check all hose clamps for tightness and corrosion. Corroded clamps must be replaced.
•Check the nuts, bolts and screws that retain equipment, hoses, etc. in the bilge for tightness and corrosion. Corroded fasteners must be replaced.
B.Topside and Supplies
Once a year, you should undertake a thorough review of the topside equipment, as well as of the critical safety supplies on your boat.
•Check cleats, rings, rails, etc. for loose or corroded fasteners, breaks, sharp edges, or other conditions that could lead to malfunction or unsafe use. Repair or replace as necessary.
•Inspect PFDs (life jackets) for tears and deterioration.
•Make certain you have enough PFDs on board for the maximum number of persons you can carry.
•Check your first aid kit, making certain it is complete and that the items in it have not passed an expiration date.
•Check the signaling equipment and emergency flares. Make sure all items are within their expiration dates.
•Inspect the anchor, mooring, and towing lines. Repair or replace as required.
•Check fire extinguishers for full charge.
4.Winterization Checklist for Boats Stored on Land
A.Boat Storage
•Store boat in a bow high attitude.
•Remove hull drain plug.
•Pour one (1) pint
B.Engine
•Flush engine with fresh water.
•Remove engine drain plugs.
Refer to your Engine Operator’s Manual for detailed information on preparing the engines for storage and winterization.
C.Battery(ies)
•Remove from boat. Remove the negative
•Remove grease and dirt from top surface.
•Grease terminal bolts.
•Store on wooden pallet or thick plastic in a cool dry place. Do not store on concrete.
342 Performance® | 8.5 |