Baja Marine 242 manual Environmental Considerations, Waste Disposal, Excessive Noise, Wake/Wash

Page 23

Section 1 • Safety

18.Environmental Considerations

The following warning is offered for boats sold in the State of California in accordance with California Heath & Safety Code §§ 25249.5-.13:

!WARNING

A wide variety of components used on this vessel contain or emit chemicals known to the State of California to cause cancer and birth defects and other reproductive harm.

Examples include:

Engine and generator exhaust

Engine and generator fuel, and other liquids such as coolants and oil, especially used motor oil

Cooking fuels

Cleaners, paints, and substances used for vessel repair

Waste materials that result from wear of vessel components

Lead from battery terminals and from other sources such as ballast or fishing sinkers

To Avoid Harm:

Keep away from engine, generator, and cooking fuel exhaust fumes.

Wash areas thoroughly with soap and water after handling the substances above.

B.Waste Disposal

Many areas prohibit overboard sewer discharge.

Close and disable flow-through waste systems to prevent discharge in such areas.

Bag all refuse until it can be disposed of ashore. Regulations prohibit disposal of plastic anywhere in the marine environment and restrict other garbage disposal within specified distances form shore.

notice

It is illegal for any vessel to dump plastic trash anywhere in the ocean or navigable waters of the United States.

C.Excessive Noise

Many areas regulate noise limits. Even if there are no laws, courtesy demands that boats operate quietly.

D.Wake/Wash

!WARNING

speed hazard- Watch your wake. It might capsize a small craft. You are responsible for damage caused by your wake.

A.Fuel and Oil Spillage

Regulations prohibit discharging fuel or oily waste in navigable waters. Discharge is defined as any action which causes a film, sheen or discoloration on the water surface, or causes a sludge or emulsion beneath the water surface. A common violation is bilge discharge. Use rags or sponges to soak up fuel or oily waste, then dispose of it properly ashore. If there is much fuel or oil in the bilge, contact a knowledgeable marine service to remove it. Never pump contaminated bilge overboard. Help protect your waters.

Fill tank(s) less than rated capacity. Allow for fuel expansion.

Power boat wakes can endanger people and vessels. Each power boat operator is responsible for injury or damage caused by the boat's wake. Be especially careful in confined areas such as channels or marinas. Observe "no wake" warnings.

!CAUTION

Reduce speed in congested waterway.

Be alert for No Wake Markers.

242 Islander®

1.13

Image 23
Contents Islander Baja MarineFor information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction Manufacturer’s Certification Service, Parts and Repair for Your BoatHull Identification Number HIN About Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Labels SafetyFire Extinguishing System Legally Mandated Minimum Required EquipmentCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Load Capacity Additional Recommended Equipment for Safe OperationImpaired Operation Stability Power CapacityGeneral Considerations Maintain ControlWeather Chart Your Course Skiing Water SportsSwimming Water Rescue Emergency SituationsGeneral Medical EmergencyCollisions and Leaking FireFlooding, Swamping and Capsizing Propulsion, Control or Steering Failure Safety HotlinesInternational Requirements GroundingWake/Wash Environmental ConsiderationsWaste Disposal Excessive NoiseNautical Terms Key to Symbols on Controls & Prints This Page Intentionally Left Blank Baja Marine Corp This Page Intentionally Left Blank Docking /Lifting /Trailering Passenger Locations General Boat ArrangementBoat Dimensions and Clearances Fig Propellers Basic Boat Dimensions and Clearances MetricPropulsion System General Deck Layout Gear Shift and Throttle Control Power Trim Unit and GaugeDescription of Major Controls Trim Tabs Trailer SwitchTachometer and Hour Meter Ignition Shutdown SwitchEngine Alarm System Important GaugesNavigation and Anchor Lights Oil Pressure, Water Temperature, Voltmeter and Fuel GaugesPre-Launch, Launch and Post- Launch Checklist Using Your BoatFueling the Boat Trailer Launching and LoadingPersonal Flotation Devices BoardingStarting the Engine Passenger Instruction and LocationStopping the Engine Shifting to Drive the BoatSteering System Power Steering SystemBilge Pumps Bilge & Underwater GearBilge Fuel & Oil SpillageVibration and Causes Maintenance and ServiceEngines and Stern Drive Bilge BlowersImpact to Stern Drive Propeller Removal and InstallationGear case Anti-Siphon Valve Inboard/Outboard Engine Only Fuel SystemFuel System Static Electricity and the Fuel System Fueling PrecautionsBefore and During Fueling Checklist After Fueling Checklist This page intentionally left blank Batteries Electrical SystemsElectrical Systems Direct Current DCFuse Panel Electrolytic Corrosion & Zinc AnodesBreakers and/or Fuses Marine Electronic Cathodic Anti-corrosion System Mercathode Drive Pump Drive Pump w/ K-Plane Trim Tabs Ignition Switch Switch Panel Wire Information FIG This Page Intentionally Left Blank Options & Accessories Locations Options & AccessoriesCanvas Automatic Fire Extinguisher System OptionFire Extinguisher Port Horn Canvas Care and MaintenanceSwim Platform w/ Ladder Optional Depth Finder OptionalPortable Head with Pump-Out Stereo SystemHead Systems Requirements for OperatorsHolding Tank Operation Exhaust SystemsVacuFlush Head Option Vent FilterInterval Required Inspection, Service MaintenanceSummary Guide for Inspection, Service and Maintenance Interval Summary Guide For Inspection, Service and MaintenanceUseful Service Information Bilge Area Inspection, Service and Maintenance ProtocolBoat Storage Winterization Checklist for Boats Stored on LandBatteryies Topside and SuppliesMiscellaneous Fitting Out After StorageFuel Systems Fuel SystemSecurity Considerations Power Steering System MaintenanceBoat Systems Quick Reference ChecklistBoarding the Boat General Starting the Engine Returning to Port General Quick Reference Checklist cont’d Departing GeneralIf the Engine Does Not Start Quick Reference Checklist cont’dSecuring the Boat After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Fiberglass & Gelcoat Paint Cleaning Agents & Other SubstancesCare & Refinishing Stains & ScratchesCanvas and Clear Vinyl Permanently Moored or Docked BoatsTopside Areas Acrylic Plastic Sheeting Plastic GlassInterior Upholstery Fabric Exterior Upholstery FabricThis Page Intentionally Left Blank Index Index Islander