Baja Marine 192 Islander manual Starting the Engine

Page 71

Section 8 • Required Inspection, Service, &

Maintenance

Quick Reference Checklist (cont’d)

B.Preparing to Depart and After Launching

General

 

 

1.

Bilge/Engine Compartment

“Sniff” the bilge/engine compartment for

fuel odor.

 

 

Run the bilge blowers for at least four (4)

minutes.

2.

Shore Power Cable

Disconnected from dockside power inlet

 

3.

Lines, Fenders and Anchor

Ready for use

 

4.

Passengers/Crew

Instructed in duties for getting underway and fitted for a

 

 

correct size PFD

 

Engine

 

 

1.

Battery Switches

In the ON position

 

2.

Fuel Valves (Diesel Only)

Open

 

3.

Engine Alarm

Test. Should sound after a few seconds

 

4.

Gear Shift & Throttle Controls

In NEUTRAL and IDLE positions

 

Starting the Engine*

 

 

1.

Gearshift & Throttle Controls

Shift in NEUTRAL (Refer to your Engine Owner’s

 

 

Manual for startup procedures for your specific

 

 

engine)

 

2.

Ignition

Turn ignition keys on the helm clockwise until engine

 

 

starts, then release.

 

IMPORTANT: Do not continue to operate starter for more than 10 seconds without pausing to allow starter motor to cool off for 2 minutes. This also will allow the battery to recover between starting attempts.*

!WARNING

Do not run the engine or generator in an enclosed area, such as a closed boat house, as there is the possibility of buildup and inhaling of carbon monoxide.

*If engine fails to start, refer to the Engine Owner’s Manual for further troubleshooting procedures

192 Islander®

8.9

Page 70 Page 72
Image 71
Page 70 Page 72
Contents Islander Baja MarineFor information call 1-865-971-6270 or fax Welcome This Page Intentionally Left Blank Introduction Manufacturer’s Certification Service, Parts and Repair for Your BoatHull Identification Number HIN About Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Labels SafetyFire Extinguishing System Legally Mandated Minimum Required EquipmentCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Load Capacity Additional Recommended Equipment for Safe OperationImpaired Operation Stability Power CapacityGeneral Considerations Maintain ControlWeather Chart Your Course Skiing Water SportsSwimming Water Rescue Emergency SituationsGeneral Medical EmergencyCollisions and Leaking FireFlooding, Swamping and Capsizing Propulsion, Control or Steering Failure Safety HotlinesInternational Requirements GroundingWake/Wash Environmental ConsiderationsWaste Disposal Excessive NoiseNautical Terms Key to Symbols on Controls & Prints This Page Intentionally Left Blank California Residents Only This Page Intentionally Left Blank Passenger Locations General Boat ArrangementDocking/Lifting/Trailering 2 Hull Propellers Basic Boat Dimensions and Clearances MetricPropulsion System General Deck Layout HornGear Shift/Throttle Control Power Trim Unit and GaugeDescription of Major Controls Tachometer and Hour Meter Ignition Shutdown SwitchEngine Alarm System Important GaugesNavigation and Anchor Lights Oil Pressure, Water Temperature, Voltmeter and Fuel GaugesThis Page Intentionally Left Blank Pre-Launch, Launch and Post- Launch Checklist Using Your BoatFueling the Boat Trailer Launching and LoadingPassenger Instruction and Location BoardingPersonal Flotation Devices Starting the Engine Shifting to Drive the Boat To Start EngineSteering System Stopping the EngineDrain Plug Bilge & Underwater GearBilge Bilge PumpsVibration and Causes Maintenance and ServiceEngines and Stern Drive Bilge BlowersImpact to Stern Drive Propeller Removal and InstallationGear case Anti-Siphon Valve Inboard/Outboard Engine Only Fuel SystemFuel System Static Electricity and the Fuel System Fueling PrecautionsBefore and During Fueling Checklist After Fueling Checklist This Page Intentionally Left Blank Batteries Electrical SystemsElectrical Systems Direct Current DCBreakers and/or Fuses Electrolytic Corrosion & Zinc AnodesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Drive Pump OFF This Page Intentionally Left Blank REaR View FROnT View Switch Panel Wire Information FIGThis Page Intentionally Left Blank Options & Accessories Locations Options & AccessoriesCanvas Canvas Care and MaintenanceAutomatic Fire Extinguisher System Option Stereo System Depth Finder OptionalHorn Swim Platform w/ Ladder OptionalThis Page Intentionally Left Blank Interval Required Inspection, Service MaintenanceSummary Guide for Inspection, Service and Maintenance Interval Summary Guide for Inspection, Service and MaintenanceUseful Service Information Bilge Area Inspection, Service and Maintenance ProtocolBoat Storage Winterization Checklist for Boats Stored on LandBatteryies Topside and SuppliesMiscellaneous Fitting Out After StorageFuel Systems Fuel SystemSecurity Considerations Power Steering System MaintenanceBoat Systems Quick Reference ChecklistBoarding the Boat General Starting the Engine Returning to Port Quick Reference Checklist cont’d DepartingIf the Engine Does Not Start Quick Reference Checklist cont’dSecuring the Boat After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Fiberglass & Gelcoat Paint Cleaning Agents & Other SubstancesCare & Refinishing Stains & ScratchesCanvas & Clear Vinyl Permanently Moored or Docked BoatsTopside Areas Acrylic Plastic Sheeting Plastic GlassInterior Upholstery Fabric Exterior Upholstery FabricThis Page Intentionally Left Blank Index Index Islander

192 Islander specifications

The Baja Marine 192 Islander is an exceptional mid-range powerboat designed for both performance and leisure. This vessel stands out for its versatility, combining sporty characteristics with the ability to provide a comfortable family outing on the water.

One of the most notable features of the Baja 192 Islander is its sleek, aerodynamic hull design. With a length of 19 feet, this boat is crafted from high-quality fiberglass, ensuring durability and resilience. The deep-V hull helps to cut through waves with ease, providing a smooth ride even in choppy waters. This design not only enhances performance but also contributes to fuel efficiency, making it an economical choice for boaters.

Powering the Baja 192 Islander is typically a potent V8 engine, delivering impressive horsepower that ensures exhilarating acceleration. The boat is built for speed, appealing to those who crave thrills on the water. The engine compartment is engineered for easy maintenance, allowing boaters to spend more time enjoying their adventures rather than worrying about upkeep.

The cockpit of the Baja 192 Islander is designed with both function and comfort in mind. The helm features a well-arranged dashboard with easy-to-read gauges and intuitive controls, ensuring that the captain has complete command over the vessel. Upholstered seating provides comfort for both the driver and passengers, while stainless steel accents add a touch of elegance.

Another significant feature of the Baja 192 Islander is its ample storage options. The boat includes several compartments for personal belongings, gear, and fishing equipment, making it ideal for various activities such as day cruising or fishing excursions. The swim platform at the rear of the boat offers an easy entry point for swimming or water sports, enhancing the overall experience.

For entertainment, the Baja 192 Islander can accommodate sound systems that allow boaters to enjoy their favorite music while on the move. The layout also allows for social gatherings, making it a great choice for family outings or trips with friends.

In conclusion, the Baja Marine 192 Islander is a perfect blend of performance, comfort, and functionality. With its impressive speed, durable build, and thoughtful features, it remains a favorite among boating enthusiasts. Whether you are seeking adventure or relaxation, the Baja 192 Islander caters to all, making it an exceptional choice for a reliable and exciting boating experience.
Top Page Image Contents