Baja Marine 202 Islander manual Quick Reference Checklist cont’d, Securing the Boat

Page 74

Section 8 • Required Inspection, Service, &

 

 

Maintenance

Quick Reference Checklist (contd)

3.

Ignition

Once the motor is cooled down, turn the ignition keys

 

 

counter clockwise to stop the engine.

4.

Engine Operation

Check idle and shift. Listen for abnormal noises

E. Securing the Boat

 

General

 

Lines and Fenders

Fenders in place, lines tied securely to dock

Boat Systems

 

1.

Helm Switch Panel

All switches in the OFF position

2.

Gearshift & Throttle Controls

In the NEUTRAL and IDLE positions

Engine

 

 

1.

Ignition

Switch is in the OFF position and ignition keys are

 

 

removed

2.

Battery Switches

In the OFF position

3.

Fuel Valves (Diesel Only)

Closed (handle perpendicular to hose)

F. If the Engine Does Not Start

No Starter Motor Response

1.Check battery switch is in the ON position.

2.Check the main circuit breaker.

3.Check gearshift/throttle control levers in the NEUTRAL positions.

4.Check battery condition for sufficient charge.

5.Check battery cable connections tight and free from corrosion.

6.Check starter motor and solenoid connections.

7.Check ignition switch connections.

8.Consult the engine manual that is located in the owners packet.

Starter Motor Responds, but No Ignition

1.Check that fuel tank is not empty.

2.Check that ignition shutdown switch lanyard is installed.

3.Check electrical connections on engine wiring harness and ignition wiring.

4.Check fuel filters and filter/water separators clean

5.Consult the engine maual that is located in the owners packet.

202 Islander®

8.11

Image 74
Contents Baja Marine IslanderFor information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction HIN Number Hull Identification Number HINAbout Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Safety LabelsCarbon Monoxide Legally Mandated Minimum Required EquipmentFire Extinguishing System Carbon Monoxide Monitor Lifesaving Equipment Additional Recommended Equipment for Safe Operation Impaired OperationPropellers Power CapacityLoad Capacity Stability Maintain ControlGeneral Considerations Chart Your CourseWeather Skiing Water SportsSwimming Emergency Situations GeneralFire Medical EmergencyWater Rescue Flooding, Swamping and CapsizingGrounding Safety HotlinesCollisions and Leaking Propulsion, Control or Steering FailureFuel and Oil Spillage International RequirementsEnvironmental Considerations Excessive Noise Waste DisposalWake/Wash Nautical Terms Key to Symbols on Controls & Prints Baja Marine Corp This Page Intentionally Left Blank General Boat Arrangement Docking /Lifting /Trailering Passenger Locations2 Hull Basic Boat Dimensions and Clearances Metric Propulsion SystemHorn General Deck LayoutGear Shift and Throttle Control Power Trim Unit and GaugeDescription of Major Controls Trailer Switch Trim TabsImportant Gauges Ignition Shutdown SwitchEngine Alarm System Tachometer and Hour MeterOil Pressure, Water Temperature, Voltmeter and Fuel Gauges Navigation and Anchor LightsUsing Your Boat Pre-Launch, Launch and Post- Launch ChecklistTrailer Launching and Loading Fueling the BoatBoarding Personal Flotation DevicesPassenger Instruction and Location Starting the EngineShifting to Drive the Boat Stopping the EngineSteering Systems Hydraulic SteeringPower Steering Power Steering SystemFuel & Oil Spillage Bilge & Underwater GearBilge Drain PlugBilge Blowers Maintenance and ServiceEngines and Stern Drive Vibration and CausesPropeller Removal and Installation Impact to Stern DriveGear case Anti-Siphon Valve Inboard/Outboard Engine Only Fuel SystemFuel System Static Electricity and the Fuel System Fueling PrecautionsBefore and During Fueling Checklist After Fueling Checklist This page intentionally left blank Direct Current DC Electrical SystemsElectrical Systems BatteriesFuse Panel Electrolytic Corrosion & Zinc AnodesBreakers and/or Fuses Marine Electronic Cathodic Anti-corrosion System Mercathode Ignition Switch Drive Pump This page intentionally left blank Switch Panel Wire Information FIG DC Wire Information FIG Options & Accessories Options & Accessories LocationsCanvas Depth Finder Optional Canvas Care and MaintenanceSwim Platform w/ Ladder Optional HornStereo System Exhaust SystemsInterval Required Inspection, Service MaintenanceSummary Guide for Inspection, Service and Maintenance Summary Guide For Inspection, Service and Maintenance IntervalUseful Service Information Inspection, Service and Maintenance Protocol Bilge AreaTopside and Supplies Winterization Checklist for Boats Stored on LandBatteryies Boat StorageFuel System Fitting Out After StorageFuel Systems MiscellaneousPower Steering System Maintenance Security Considerations Boat Systems Quick Reference Checklist Boarding the Boat General Starting the Engine Quick Reference Checklist cont’d Departing General Returning to Port GeneralIf the Engine Does Not Start Quick Reference Checklist cont’dSecuring the Boat After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Stains & Scratches Paint Cleaning Agents & Other SubstancesCare & Refinishing Fiberglass & GelcoatAcrylic Plastic Sheeting Plastic Glass Permanently Moored or Docked BoatsTopside Areas Canvas and Clear VinylExterior Upholstery Fabric Interior Upholstery FabricThis Page Intentionally Left Blank Index Index Islander