Baja Marine 230 manual Boarding, Personal Flotation Devices

Page 39

Section 3 • Using Your Boat

•Shut off gas burning appliances (gas stove, etc.).

•Close all hatches, doors, and keep engine compartment closed to prevent gasoline fumes from entering the cabin or cockpit area.

•All passengers must leave the boat until it is refueled and engine is safely started.

•Assist passengers back into the boat.

4.Boarding

!WARNING

Wet decks are slippery.

You can be seriously injured if you slip and fall.

•There must be no smoking or any flames within 20 feet of the boat, before, during, and for at least 5 minutes after fueling is completed.

Wear slip-resistant footwear secured to your feet and hold onto rails or boat structure.

•Open fuel fill cap and insert hose nozzle into the fuel fill opening. Fuel fill hose nozzle must contact the fuel fill opening BEFORE adding fuel to prevent discharge of static electricity.

Filling The Tanks

•Check the fill plate label to ensure that fuel is placed ONLY in the fuel tank. The fuel fill plates are located on the port side of your boat (Figure 3.2.1).

•Keep nozzle in contact with fuel fill opening at all times during fueling.

•Listen as tank fills and stop adding fuel before it spills from the vent. Fuel must have room for expansion.

•Look for leaking fuel near fuel fill and near tank.

After Filling

•DO NOT wash spilled fuel overboard. Wipe up any spill with rags or paper towels and dispose of them properly on shore.

•Open engine compartment and look for fuel leaks or smell for fumes. This is especially important if your boat is equipped with gasoline engines. Leave compartment open until no odor is apparent. Close compartment.

•If fumes in the engine compartment do not disappear, do not turn on blower or start engine. Get help from trained and experienced persons before using the boat.

•Turn on blower for four minutes, then restart engine.

•DO NOT overload the boat.

•Board one person at a time and give assistance as needed.

•Transfer gear and equipment by handing it from a person on the dock to a person on board. You can lose your balance and be injured if you attempt to board while carrying equipment or gear.

•Distribute the weight of equipment and passengers as evenly as possible to keep the boat balanced.

•Stow gear and equipment so that it is accessible, but everything is to be stored in places so as to prevent it from flying about if the boat encounters rough water or weather.

5.Personal Flotation Devices

(PFD’s)

•Operator must instruct all passengers on location and use of PFD’s (See Section 1- Safety, page 4 for type and usage).

•Children and all non-swimmers, adults as well as children, must wear properly-sized PFDs at all times when aboard. Check applicable state regulations for PFD wear requirements.

•ALL passengers should wear PFDs. By the time someone falls overboard, it can be to late for them to put on a PFD and fasten it properly. This is especially true in colder waters, below 70o F, where survival time, before hypothermia sets in, is measured in minutes.

230 Sportfish® TE

3.3

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Baja Marine For information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction Service, Parts and Repair for Your Boat Hull Identification Number HINManufacturer’s Certification About Your Express Limited Warranty Iii Static Electricity and the Fuel System Speed changes you. TM Safety Labels SafetyCarbon Monoxide Legally Mandated Minimum Required EquipmentUsing canvas curtains Operating with the bow high Lifesaving Equipment Impaired Operation Additional Recommended Equipment for Safe OperationPower Capacity Load CapacityPropellers Maintain Control StabilityChart Your Course WeatherGeneral Considerations Water Sports SwimmingSkiing General Emergency SituationsFlooding, Swamping and Capsizing Medical EmergencyWater Rescue FirePropulsion, Control or Steering Failure Safety HotlinesCollisions and Leaking GroundingInternational Requirements Environmental ConsiderationsFuel and Oil Spillage Waste Disposal Wake/WashExcessive Noise Nautical Terms Key to Symbols on Controls & Prints Baja Marine Corp This Page Intentionally Left Blank Docking /Lifting /Trailering Passenger Locations General Boat Arrangement2 Hull Propulsion System Basic Boat Dimensions and Clearances MetricGeneral Deck Layout FIG General Deck LayoutPower Trim Unit and Gauge Description of Major ControlsGear Shift and Throttle Control Trim Tabs Trailer SwitchTachometer and Hour Meter Ignition Shutdown SwitchEngine Alarm System Important GaugesNavigation and Anchor Lights Oil Pressure, Water Temperature, Voltmeter and Fuel GaugesPre-Launch, Launch and Post- Launch Checklist Using Your BoatFueling the Boat Trailer Launching and LoadingPersonal Flotation Devices BoardingStarting the Engine Passenger Instruction and LocationStopping the Engine Shifting to Drive the BoatHydraulic Steering Steering SystemsPower Steering System Power SteeringThis page intentionally left blank Drain Plug Bilge & Underwater GearBilge Fuel & Oil SpillageVibration and Causes Maintenance and ServiceEngines and Stern Drive Bilge BlowersImpact to Stern Drive Propeller Removal and InstallationGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Fueling Precautions Before and During Fueling ChecklistStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Batteries Electrical SystemsElectrical Systems Direct Current DCElectrolytic Corrosion & Zinc Anodes Breakers and/or FusesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Ignition Switch Drive Pump Drive Pump with K-Plane Trim Tabs Twin FIG This Page Intentionally Left Blank Options & Accessories Locations Options & AccessoriesDepth Finder Optional Canvas Care and MaintenanceCanvas HornRequirements for Operators Stereo SystemHead Systems Exhaust SystemsThis page intentionally left blank Required Inspection, Service Maintenance Summary Guide for Inspection, Service and MaintenanceInterval Interval Summary Guide For Inspection, Service and MaintenanceUseful Service Information Bilge Area Inspection, Service and Maintenance ProtocolBoat Storage Winterization Checklist for Boats Stored on LandBatteryies Topside and SuppliesMiscellaneous Fitting Out After StorageFuel Systems Fuel SystemSecurity Considerations Power Steering System MaintenanceQuick Reference Checklist Boarding the Boat GeneralBoat Systems Starting the Engine Returning to Port General Quick Reference Checklist cont’d Departing GeneralQuick Reference Checklist cont’d Securing the BoatIf the Engine Does Not Start After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Fiberglass & Gelcoat Paint Cleaning Agents & Other SubstancesCare & Refinishing Stains & ScratchesCanvas and Clear Vinyl Permanently Moored or Docked BoatsTopside Areas Acrylic Plastic Sheeting Plastic GlassInterior Upholstery Fabric Exterior Upholstery FabricThis Page Intentionally Left Blank Index Index Sportfish TE

230 specifications

The Baja Marine 230 is a striking example of performance and style in the realm of high-performance boats. Renowned for its sleek design and aggressive aesthetic, this vessel is engineered for enthusiasts who crave exhilarating speed, agile handling, and a thrilling boating experience.

One of the standout features of the Baja Marine 230 is its impressive powertrain, which typically includes potent engine options that deliver remarkable horsepower. With a standard engine often exceeding 300 horsepower, it can achieve impressive top speeds that delight both novice and seasoned boaters. The boat's shape is meticulously crafted to reduce drag and enhance performance, ensuring that every dash across the water is thrilling.

The hull design of the Baja 230 is a notable characteristic, featuring a deep-V configuration that allows for excellent stability and a smooth ride even in choppy waters. This design minimizes the impact of waves, giving passengers a comfortable experience during high-speed cruising. Additionally, it is built to handle sharp turns and rapid accelerations, putting control firmly in the hands of the captain.

In terms of technology, the Baja Marine 230 often includes advanced instrumentation, with easy-to-read gauges and digital displays that provide real-time data on speed, fuel levels, and engine performance. This modern cockpit design not only enhances usability but also introduces an element of sophistication to the overall boating experience.

Comfort and luxury are not neglected in the Baja Marine 230. The cockpit typically features plush, ergonomically designed seating, accommodating guests while still leaving room for movement. Many models also come equipped with amenities such as high-quality sound systems, customizable lighting, and plenty of storage options, making it ideal for day trips and longer excursions alike.

Safety is paramount, and the Baja Marine 230 is built with sturdy construction materials that ensure durability and reliability on the water. Features such as non-slip surfaces, handrails, and well-placed grab handles contribute to a safe boating experience for all onboard.

Overall, the Baja Marine 230 stands out as a premium choice for fans of performance boating. Its combination of power, design, technology, and comfort makes it a formidable presence on the water, ready to deliver unforgettable adventures for those who dare to take command.
Top Page Image Contents