Baja Marine 230 manual Starting the Engine

Page 72

Section 8 • Required Inspection, Service, &

Maintenance

Quick Reference Checklist (cont’d)

B.Preparing to Depart and After Launching

General

 

 

1.

Bilge/Engine Compartment

“Sniff” the bilge/engine compartment for

fuel odor.

 

 

Run the bilge blowers for at least four (4)

minutes.

2.

Shore Power Cable

Disconnected from dockside power inlet

 

3.

Lines, Fenders and Anchor

Ready for use

 

4.

Passengers/Crew

Instructed in duties for getting underway and fitted for a

 

 

correct size PFD

 

Engine

 

 

1.

Battery Switches

In the ON position

 

2.

Fuel Valves (Diesel Only)

Open

 

3.

Engine Alarm

Test. Should sound after a few seconds

 

4.

Gear Shift & Throttle Controls

In NEUTRAL and IDLE positions

 

Starting the Engine*

 

 

1.

Gearshift & Throttle Controls

Shift in NEUTRAL (Refer to your Engine Owner’s

 

 

Manual for startup procedures for your specific

 

 

engine)

 

2.

Ignition

Turn ignition keys on the helm clockwise until engine

 

 

starts, then release.

 

IMPORTANT: Do not continue to operate starter for more than 10 seconds without pausing to allow starter motor to cool off for 2 minutes. This also will allow the battery to recover between starting attempts.*

!WARNING

Do not run the engine or generator in an enclosed area, such as a closed boat house, as there is the possibility of buildup and inhaling of carbon monoxide.

*If engine fails to start, refer to the Engine Owner’s Manual for further troubleshooting procedures

230 Sportfish® TE

8.9

Page 71 Page 73
Image 72
Page 71 Page 73
Contents Baja Marine For information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction Service, Parts and Repair for Your Boat Hull Identification Number HINManufacturer’s Certification About Your Express Limited Warranty Iii Static Electricity and the Fuel System Speed changes you. TM Safety Safety LabelsLegally Mandated Minimum Required Equipment Carbon MonoxideUsing canvas curtains Operating with the bow high Lifesaving Equipment Additional Recommended Equipment for Safe Operation Impaired OperationPower Capacity Load CapacityPropellers Stability Maintain ControlChart Your Course WeatherGeneral Considerations Water Sports SwimmingSkiing Emergency Situations GeneralMedical Emergency Water RescueFire Flooding, Swamping and CapsizingSafety Hotlines Collisions and LeakingGrounding Propulsion, Control or Steering FailureInternational Requirements Environmental ConsiderationsFuel and Oil Spillage Waste Disposal Wake/WashExcessive Noise Nautical Terms Key to Symbols on Controls & Prints Baja Marine Corp This Page Intentionally Left Blank General Boat Arrangement Docking /Lifting /Trailering Passenger Locations2 Hull Basic Boat Dimensions and Clearances Metric Propulsion SystemGeneral Deck Layout General Deck Layout FIGPower Trim Unit and Gauge Description of Major ControlsGear Shift and Throttle Control Trailer Switch Trim TabsIgnition Shutdown Switch Engine Alarm SystemImportant Gauges Tachometer and Hour MeterOil Pressure, Water Temperature, Voltmeter and Fuel Gauges Navigation and Anchor LightsUsing Your Boat Pre-Launch, Launch and Post- Launch ChecklistTrailer Launching and Loading Fueling the BoatBoarding Personal Flotation DevicesPassenger Instruction and Location Starting the EngineShifting to Drive the Boat Stopping the EngineSteering Systems Hydraulic SteeringPower Steering Power Steering SystemThis page intentionally left blank Bilge & Underwater Gear BilgeFuel & Oil Spillage Drain PlugMaintenance and Service Engines and Stern DriveBilge Blowers Vibration and CausesPropeller Removal and Installation Impact to Stern DriveGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Fueling Precautions Before and During Fueling ChecklistStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Electrical Systems Electrical SystemsDirect Current DC BatteriesElectrolytic Corrosion & Zinc Anodes Breakers and/or FusesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Ignition Switch Drive Pump Drive Pump with K-Plane Trim Tabs Twin FIG This Page Intentionally Left Blank Options & Accessories Options & Accessories LocationsCanvas Care and Maintenance CanvasHorn Depth Finder OptionalStereo System Head SystemsExhaust Systems Requirements for OperatorsThis page intentionally left blank Required Inspection, Service Maintenance Summary Guide for Inspection, Service and MaintenanceInterval Summary Guide For Inspection, Service and Maintenance IntervalUseful Service Information Inspection, Service and Maintenance Protocol Bilge AreaWinterization Checklist for Boats Stored on Land BatteryiesTopside and Supplies Boat StorageFitting Out After Storage Fuel SystemsFuel System MiscellaneousPower Steering System Maintenance Security ConsiderationsQuick Reference Checklist Boarding the Boat GeneralBoat Systems Starting the Engine Quick Reference Checklist cont’d Departing General Returning to Port GeneralQuick Reference Checklist cont’d Securing the BoatIf the Engine Does Not Start After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Paint Cleaning Agents & Other Substances Care & RefinishingStains & Scratches Fiberglass & GelcoatPermanently Moored or Docked Boats Topside AreasAcrylic Plastic Sheeting Plastic Glass Canvas and Clear VinylExterior Upholstery Fabric Interior Upholstery FabricThis Page Intentionally Left Blank Index Index Sportfish TE

230 specifications

The Baja Marine 230 is a striking example of performance and style in the realm of high-performance boats. Renowned for its sleek design and aggressive aesthetic, this vessel is engineered for enthusiasts who crave exhilarating speed, agile handling, and a thrilling boating experience.

One of the standout features of the Baja Marine 230 is its impressive powertrain, which typically includes potent engine options that deliver remarkable horsepower. With a standard engine often exceeding 300 horsepower, it can achieve impressive top speeds that delight both novice and seasoned boaters. The boat's shape is meticulously crafted to reduce drag and enhance performance, ensuring that every dash across the water is thrilling.

The hull design of the Baja 230 is a notable characteristic, featuring a deep-V configuration that allows for excellent stability and a smooth ride even in choppy waters. This design minimizes the impact of waves, giving passengers a comfortable experience during high-speed cruising. Additionally, it is built to handle sharp turns and rapid accelerations, putting control firmly in the hands of the captain.

In terms of technology, the Baja Marine 230 often includes advanced instrumentation, with easy-to-read gauges and digital displays that provide real-time data on speed, fuel levels, and engine performance. This modern cockpit design not only enhances usability but also introduces an element of sophistication to the overall boating experience.

Comfort and luxury are not neglected in the Baja Marine 230. The cockpit typically features plush, ergonomically designed seating, accommodating guests while still leaving room for movement. Many models also come equipped with amenities such as high-quality sound systems, customizable lighting, and plenty of storage options, making it ideal for day trips and longer excursions alike.

Safety is paramount, and the Baja Marine 230 is built with sturdy construction materials that ensure durability and reliability on the water. Features such as non-slip surfaces, handrails, and well-placed grab handles contribute to a safe boating experience for all onboard.

Overall, the Baja Marine 230 stands out as a premium choice for fans of performance boating. Its combination of power, design, technology, and comfort makes it a formidable presence on the water, ready to deliver unforgettable adventures for those who dare to take command.
Top Page Image Contents