Attwood 3810, 3820 warranty Features, Required for Installation, Location, Mounting Instructions

Page 1

3®

3800 Series Stainless Steel 2-Mile Sidelights

Bicolor Combination Bow Light: 3810

Sidelight Pair: 3820

Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69360 Rev. A

00-01

FEATURES

The Attwood Stainless Steel sidelights provide 2-mile visibility with advanced optics for greater visibility and safety. The housing is corrosion-proof with an aerodynamic design for an attractive appearance on the deck of your boat. The base gasket forms a seal between the lens and deck for an easy, waterproof installation. Side reflectors provide added protection even when the light is not on. These lights exceed all requirements of ABYC A-16-97 and COLREG 72 for boats up to 20 meters/65.6 feet (BiColor Bow Light 3810) and up to 50 meters/164 feet (Sidelight Pair 3820).

REQUIRED FOR INSTALLATION

Phillips screwdriver

Drills: ³⁄₄" for wire clearance hole Pilot drill for mounting screws

Two #10 pan head stainless steel screws (not included)

LOCATION

1. Position light(s) on a surface of the gunwale or deck that is

horizontal (within +/-5 degrees).

2. When installing bicolor combination light, place it on the

centerline of the boat at the bow (See Figure 1a).

When installing sidelight pairs, place lights with the red lens

on the port (left) and green lens on the starboard (right) as you

4.Measure and mark location of wire clearance hole. If installing a bicolor light, location must be on the boat centerline. If installing a sidelight pair, both must be the same distance from the bow.

At the marked location(s), make a mark for a ³⁄₄" hole. This hole is necessary for wire passage and lamp ventilation (See Figure 2).

Figure 2

Cover Screw

Lens Cover

Lens

#10 Stainless Steel

 

Mounting Screws

 

O-Ring

 

Base

Gasket

stand onboard facing bow of the boat. Lights must be parallel

to centerline of the boat (See Figure 1b).

Butt-Joint Connectors

Figure 1a

Figure 1b

3/4" Hole Aligned with Boat Centerline

Red

Green

(Port)

(Starboard)

Red

Green

(Port)

(Starboard)

3.Make sure there are no obstructions at the front or side such as rail stanchions, chocks, anchors, cleats, etc. within the light’s arc of visibility (112.5 degrees each side).

MOUNTING INSTRUCTIONS

1.Remove the cover and lens by removing the Phillips head screw in the cover and lifting off (See Figure 2).

2.Align hole beneath light base with the position you’ve marked for the clearance hole. Set lens toward the bow and align arrow on base with the boat centerline. Use the light base as a template to mark locations for the mounting screw pilot holes (use at least 2 #10 stainless steel screws).

CAUTION:

Position holes carefully on aluminum boats so that wires do not contact the hull.

3. Drill clearance hole and pilot holes for the mounting screws.

WIRING INSTRUCTIONS

The power supply must be 12-volt DC ONLY. Use crimp type marine-grade connectors with suitable insulation. Protect all connections with suitable materials.

NOTE:

Failure to make proper connections and fuse the light properly (see back page) will void the product warranty.

Image 1
Contents Required for Installation FeaturesWiring Instructions LocationAttwood Limited Warranty Maintenance