IBM xSeries 330 manual Error Code/Symptom

	Error Code/Symptom			FRU/Action
0001200	(Machine check architecture	1.	Processor 1
error)		2.	Optional Processor 2
		3.	System Board.
1600	(The Service Processor is not	1.	Do the following before replacing a FRU:
functioning) Do the following before			a.	Ensure that a jumper is not installed on J28.
replacing a FRU:
			b.	Remove the ac power to the system, wait 20 seconds; then, re-
				connect the ac power. Wait 30 seconds; then, power-on the
				system.
		2.	System Board
1601	(The system is able to	1.	Do the following before replacing a FRU:
communicate to the Service Processor, but			a.	Remove the ac power to the system, wait 20 seconds; then, re-
the Service Processor failed to respond at
				connect the ac power. Wait 30 seconds; then, power-on the
the start of POST.)
				system.
			b.	Flash update the Service Processor.
		2.	System Board
1762	(Fixed Disk Configuration error)	1.	Fixed Disk Drive
(IDE drive only)		2.	Fixed Disk Cables
		3.	Run Configuration/Setup
		4.	System Board
178X	(Fixed Disk error) (IDE drive	1.	Fixed Disk Cables
only)		2.	Run Diagnostics
		3.	Fixed Disk Drive
		4.	System Board
1800	(No more hardware interrupt	1.	Run Configuration/Setup
available for PCI adapter)		2.	Remove Adapter
1801 (no more ROM space available for		1.	Run Configuration/Setup
PCI adapter)		2.	Remove adapter
		3.	Disable adapter BIOS on adapter and run Configuration/Setup
1962	(Drive does not contain a valid	1.	Verify a bootable operating system is installed.
boot sector)		2.	Run Diagnostics
		3.	Hard Disk Drive
		4.	SCSI Backplane
		5.	Cable
		6.	System Board
2400	(Video controller test failure)	1.	Video Adapter (if installed)
		2.	System Board
2462	(Video memory configuration	1.	Video Adapter (if installed)
error)		2.	System Board

Chapter 7. Symptom-to-FRU index 93