Installing the microprocessor
Complete the following steps to install an additional microprocessor:
Attention: When you handle electrostatic
1.Review the safety precautions listed in “Safety information” on page 107.
2.Turn off the server and peripheral devices and disconnect the power cord and all external cables; then remove the cover (see “Removing the cover” on page 44 for details).
3.Remove the clear shield from the server and store it in a safe place.
4.Lift up the microprocessor release lever and remove the terminator card from the microprocessor connector. (After you remove the new microprocessor from the
5.Install the microprocessor:
a.Touch the
b.Orient the microprocessor over the microprocessor connector as shown in the illustration. Carefully press the microprocessor into the connector.
Note: To avoid bending the pins on the microprocessor, do not use excessive force when pressing it into the connector.
Microprocessor |
|
orientation indicator | Microprocessor |
Microprocessor
Microprocessorconnector release lever
Rear of server
56 Hardware Maintenance Manual: xSeries 330