IBM xSeries 330 manual Diagnostic error codes, 000The test passed

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197 do not replace a FRU. The description for these error codes are:

000The test passed.

195The Esc key was pressed to abort the test.

197This is a warning error and may not indicate a hardware failure. For all error codes, replace/follow the FRU/Action indicated.

Error Code/Symptom			FRU/Action
001-XXX-000	(Failed core tests)	1.	System Board
001-XXX-001	(Failed core tests)	1.	System Board
001-250-000	(Failed System Board	1.	System Board
ECC)
001-250-001	(Failed Processor	1.	System Board
Board ECC)
005-XXX-000	(Failed Video test)	1.	Video adapter (if installed)
		2.	System Board
011-XXX-000	(Failed COM1 Serial	1.	Check loopback plug connected to externalized serial port
Port test)		2.	Check cable from externalized port to system board. Should connect
			to Serial Port A on the system board (J52).
		3.	System Board
011-XXX-001	(Failed COM2	1.	Check loopback plug connected to externalized serial port
Serial Port test)		2.	Check cable from externalized port to system board. Should connect
			to Serial Port B on the system board (J51).
		3.	System Board
014-XXX-000	(Failed Parallel Port	1.	System Board
test)
015-XXX-001(USB interface not found,		1.	System Board
board damaged)
015-XXX-198(USB device connected during		1.	Remove USB devices from USB1 and USB2.
USB test)		2.	System Board
020-XXX-000	(Failed PCI Interface	1.	System Board
test)
030-XXX-000	(Failed Internal SCSI	1.	System Board
interface test)
035-XXX-099		1.	No RAID adapters were found.
		2.	If adapter is installed re-check connection.
035-XXX-S99	(Failed RAID test on PCI	1.	RAID Adapter
slot S, check System Error Log before		2.	SCSI Backplane
replacing a FRU)
		3.	Cable
035-XXX-SNN	(Check System Error Log	1.	Fixed Disk with SCSI ID NN on RAID adapter in PCI slot S.
before replacing a FRU, NN = SCSI ID of
failing fixed disk)

Chapter 7. Symptom-to-FRU index 87