Dell TL2000 manual Error Code Description User Action

Table 8-1. Error Codes

Error Code	Description	User Action
30	SCSI: transport element full
31	SCSI: all slots empty
32	SCSI: invalid opcode
33	SCSI: invalid element address
34	SCSI: invalid field in CDB
35	SCSI: Invalid drive specified
36	SCSI: SEND DIAGNOSTIC command:
	invalid test number
37	SCSI: invalid LUN
38	SCSI: parameter list length error	Check the application software.
39	SCSI: parameter list error: invalid field
3A	SCSI: parameter list error: parameter not
	supported
3B	SCSI: parameter value invalid
3C	SCSI: saving parameters not supported
3D	SCSI: invalid ID message
3E	SCSI: destination element full
3F	SCSI: source slot or drive empty
40	SCSI: wrong checksum
41	SCSI: command sequence error
42	SCSI: drive disabled	Check your configuration settings.
43	SCSI: mailslot disabled
44	SCSI: flash image does not fit bootcode
45	SCSI: media removal prevented by drive	Check the application software.
46	SCSI: media removal prevented by
	library
47	SCSI: flash image does not fit personality	Check the version of code used for the upgrade.
48	SCSI: drive type not supported in this	Check if a version of code is available which supports this
	library	drive type.
49	SCSI: incompatible magazine, magazine	Check your configuration settings.
	not accessible
4A	SCSI: source not ready	Complete move process and retry operation.
4B	SCSI: destination source not ready
4C	SCSI: library controller busy	Complete process and retry operation.
4D	SCSI: cannot make reservation
		Check application software.
4E	SCSI: invalid slave robotic controller
	request
4F	SCSI: robotic axes/motors aren’t	Check robotics status.
	initialized

8-2Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide