Dell TL2000 manual Configure Set Access PIN, Configure Restore Defaults

–Web Interface (IPv6 Only and Dual Stack): Monitor Library → Library

Identity

v DHCP - (Dynamic Host Configuration Protocol) If this is enabled, your library host will negotiate the connection with the library. If DHCP is disabled, the following information is necessary to establish the remote access.

vIP Address - the IP address of the library

vNetmask - the Network Mask address of the library

vGateway - the Gateway address of the library

vEthernet - the current speed setting of the ethernet interface

Configure: Set Access PIN

Use this menu item to enable/disable, set or change the Access PIN (personal identification number) which is used to restrict access to the Control, Configure, and Service menus.

The Operator Control Panel (OCP) pin is turned off by default, but it is strongly recommended to be enabled if your environment requires unit security. Enabling the OCP pin feature prevents the unit settings from being tampered with. Users will be allowed to review the library status and manipulate media without entering the OCP pin.

If a unit administrator needs to make a configuration change in the unit, the OCP will ask for the 4-digit code in order to allow access to make changes. Once all the changes are completed the pin access will expire after 5 minutes of inactivity in the OCP (there is no log-out function in the library for this feature). A library reboot is recommended after making configuration changes to the library.

Configure

Set Access PIN

Figure 5-16. Configure: Set Access PIN menu

a77ug057

Configure: Restore Defaults

Use this menu item to restore the factory default settings.

When reducing the number of drives in your library, factory default settings must be restored to remove the Attention LED on the front panel and the exclamation mark on the Home screen indicating that a drive is missing.

Configure

Restore Default

Figure 5-17. Configure: Restore Defaults menu

a77ug045

Important: Restoring factory defaults will wipe out all the previous configuration data. The user must restore factory defaults when library drive configurations are

5-24Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide