
1 | 3 | 2 |
1 | 4 | 2 |
a77ug133
Figure 4-7. Examples of EIA units for round hole and square hole installations
Two EIA units for round hole and square hole installation
Wide Gaps within the EIA unit
Narrow Gaps between EIA units
3.Remove the adhesive security tape on the backside of the rails. Using the screws for your rack type (round holes or square holes) and a #2 Phillips screwdriver and ensuring that the flange on each rail points toward each other to form a shelf, secure one rail to each side of the rack in your chosen rack
location. Secure both the front and back of each rail to the rack, then tighten all 8 screws. The narrow end of each rail goes to the rear of the rack. The rails extend to fit a variety of rack depths. Each rail requires 2 EIA units of rack
space ( | in Figure |
1
a77ug009