Dell TL2000 manual 2U Library, Replacing a Power Supply

2U Library 4U Library

a77ug203

Figure 10-8. Diagrams for applying conductive tape for ESD protection to the back of a drive sled installed in a 2U or 4U library

Note: The small gray markers show where conductive tape should be placed to provide ESD protection.

13. Push the black tab ( in Figure 10-5 on page 10-4)back underneath the library. When inserted properly, only the handle of the tab will be visible.

14.Upgrade library firmware and drive firmware to the latest version.

Note: Go to http://support.dell.com to download the latest firmware for your library and tape drive(s).

15.Run the Library Verify test. (Operator Control Panel: Service → Library Verify). This test requires the use of a scratch (blank) cartridge.

v If the test passes:

–When prompted by the Operator Control Panel display and the I/O Station opens, remove the cartridge used in the test.

–Close the I/O Station by pushing it back into the library.

–Press Cancel to exit the Library Verify screen.

–Resume normal library operations.

vIf the test fails, an error code will be displayed. Make note of the error, then refer to the Troubleshooting chapter in this document for additional instructions.

16.Return the failed drive sled to Dell.

Replacing a Power Supply

1.Power OFF the library by pressing and holding down the power button for 4 seconds.

2.Disconnect the power cord from the electrical source, then from the library.

Chapter 10. Check, Adjust, Remove, and Replace 10-7