Dell TL2000 manual Appendix D. Enabling LUN Support in Linux D-3

5.Add the /LUNS switch to the load line of the appropriate SCSI driver. If a dual channel card is installed and the user is unsure which channel the LUN device is attached to, simply edit both lines.

LOAD ADPT160M.HAM SLOT=201 /LUNS LOAD ADPT160M.HAM SLOT=202 /LUNS

6.After the STARTUP.NCF file has been edited, save the file and reboot the server to activate the new STARTUP.NCF.

7.Upon reboot navigate to the System Console and type scan all. This will start a scan of all the LUNS on each adapter.

8.When the scan is complete, verify the LUN device has been detected using the list storage adapters command. Typical output with both the tape drive and loader being recognized:

0x08 [V321-A3] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 201] 0x16 [V321-A3-D5:1] DELL PV-124T 0031

0x15 [V321-A3-D5:0] IBM ULTRIUM-TD3 5BG2

0x09 [V321-A4] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 202]

Netware may display unbound device, meaning a driver is not bound to the loader unless a driver from a backup software is loaded. This does not prevent the backup application from detecting the LUN and binding the appropriate driver.

Note: The user must type the command scan all upon OS boot every time. If backup software services automatically start on OS boot, the user must disable them, run the scan all command, and re-enable the services.

Appendix D. Enabling LUN Support in Linux D-3