SECTION IX
TROUBLESHOOTING
WARNING: YOU MUST DISCONNECT and LOCKOUT THE ELECTRICAL SUPPLY and THE GAS SUPPLY BEFORE ANY COVERS or GUARDS ARE REMOVED FROM THE MACHINE TO ALLOW ACCESS FOR CLEANING, ADJUSTING, INSTALLATION OR TESTING OF ANY EQUIPMENT per OSHA (Occupational Safety and Health Administration) STANDARDS.
The information provided will help isolate the most probable components associated with the difficulty described. The experienced technician realizes, however, that a loose connection, or broken or shorted wire may be at fault where electrical components are concerned. DO NOT necessarily suspect the component itself. Electrical parts should always be check for failure before being returned to the factory.
IMPORTANT: When replacing blown fuses, the replacement must be of the exact rating as the fuses being replaced. The information provided should not be misconstrued as a handbook for use by an untrained person in making repairs.
WARNING: ALL SERVICE AND TROUBLESHOOTING SHOULD BE PERFORMED BY A QUALIFIED PROFESSIONAL or SERVICE AGENCY.
WARNING: WHILE MAKING REPAIRS, OBSERVE ALL SAFETY PRECAUTIONS DISPLAYED ON THE DRYER or SPECIFIED IN THIS MANUAL.
The following information assumes that the reader has familiarized himself with the introduction to this manual, understands the dryer operation, and has knowledge of the programming features of the dryer.
|
| PAGE |
TROUBLESHOOTING TABLE OF CONTENTS | NUMBER | |
A. POWER MALFUNCTIONS | 52 | |
B. BURNER IGNITION | 61 | |
C. | TUMBLER (BASK ET) ELECTRICAL MALFUNCTIONS | 74 |
D. | BASE SECTION ELECTRICAL MALFUNCTIONS | 82 |
E. | PENDENT CONTROL | 87 |
F. | TEMPERATURE SENSING | 90 |
G. | MOTORS | 93 |
H. | PLC (PROGRAMMABLE LOGIC CONTROLLER) MESSAGES | 95 |
51
