DESIGNER SOLUTIONS
7.4. SUMMARY OF COMMANDS
1) | [STATUS] | Display card status |
2) | [CLR] | Reset card to defaults |
3) | [VER] | Display firmware version |
4) | [ONmX] | Turn ON single output |
5) | [ON] | Turn ON all outputs |
6) | [OFFmX] | Turn OFF single output |
7) | [OFF] | Turn OFF all outputs |
8) | [InOmX] | Connect to one output |
9) | [InO*] | Connect to all outputs |
10) | [...P] | Sets the path, [SW] preload |
11) | [SW] | Switch preloaded outputs |
12) | [AUTO*] | |
13) | [AUTO0] | |
14) | [AUTO1] | |
15) | [AUTO2] | |
16) | [HELP] | Display available commands |
17) | [?] | Display system information |
18) | [STA1] | |
19) | [STA0] | |
20) | [...S] | Save current setting |
21) | [AFB] | Enable/disable “[ ]” |
22) | [SIDn] | Set all Card IDs |
23) | [RSI] | Reset Card IDs to defaults |
TROUBLESHOOTING GUIDE | 8 |
We have carefully tested and found no problems in the supplied
8.1 POWER LEDS ARE OFF
Cause 1: The unit is not plugged in.
Solution: Make sure the power adapter is plugged into a working AC outlet and that the adapter’s DC end is plugged all the way into the
Cause 2: The unit has a problem.
Solution: If one power LED is on, but the other is not then the
(714)
8.2NO DISPLAY
Cause 1: The source has a problem.
Solution: Check the source and make sure that there is a signal present and all source connections are correct. If the source is working and there is still no display, see Cause 2.
Cause 2: The output is not selected.
Solution: Verify the connection status of the
Cause 3: Cable connections are incorrect.
Solution: Make sure that cables are properly connected. Also, make sure that the continuity and wiring are good. If there is still no display present, see Cause 4.
Cause 4: The display has a problem.
Solution: Make sure the display is powered and turned on. If there is still no display, please call ALTINEX at (714)
19 |
