Chapter 3
Troubleshooting
Use the table below to troubleshoot common problems. If you still experience problems, please contact Avaya Communication Technical Support.
Problem | Probable Cause | Solution |
|
|
|
BIT LED remains ON | Module | i) Check that the module is |
after power up or reset |
| correctly and fully inserted into |
|
| the M770 ATM switch chassis |
|
| ii) Reboot or |
All LEDs remain ON | Module fault | Reboot or |
after power up or reset |
|
|
Port LED blinks while | Link failure | Check the fiber connection to the |
function LED is on |
| port |
LNK |
|
|
OPR LED does not | The module may be in | Reset the module again but this |
light ON after reboot | Monitor mode because | time make a Short Reset (less than 4 |
(after more than 30 | of a Long Reset | seconds) |
seconds) |
|
|
9 |