Inserting the Module into the Chassis

Chapter 2

Installation

•While holding the module by its handles, place it onto the top and bottom guide rails in the chassis and gently slide it in by pressing in the middle of the module. The module should slide in smoothly.

Caution: Ensure that the metal edges of the card (not the PCB) are aligned with the guide rails. Align the bottom edge first and then the top edge since the module slots in the bottom rail before the top rail.

•Plug in the module by pressing firmly on the mid-section of the front panel. Fold down the handles and secure the module using the two screws at the top and bottom of the front panel. Do not over-tighten the screws.

Note: Even though the modules are hot-swappable, a self initialization period is required when inserting them into the chassis. Allow about 30 seconds initialization time after inserting the module for self testing and decompression of code from Flash to RAM. If the local LECS is in Resilient mode then it will take 2 minutes for the LANE to function (see the Avaya M770 ATM Switch User’s Guide).