9.[InO*]
This command connects one input to all outputs. Command Format: [InO*]
n = Input No. (m = # from 1 to 8) Example:
Connect Input 1 to all outputs by sending [I1O*]. Input 1 is then connected to Outputs 1A, 1B, 2A, and 2B.
10.[…P]
This command sets the path for switching the outputs, but it is not active until the switch command, [SW], is executed. Switching commands ending in "P" are not executed immediately. The path for outputs on multiple units or the same unit can be preloaded.
Example:
See the example for the [SW] command that follows.
11.[SW]
This command immediately connects inputs and outputs previously set with the PATH command. The command switches all paths set on one or more units on the RS-232 bus.
Example: | |
[I1O1AP] | Nothing is physically switched. |
[I2O1BP] | Nothing is physically switched. |
[SW] | Inputs 1 & 2 are switched |
| simultaneously. |
12.[AUTO*]
This command enables auto-switching to all outputs. The UT250-101automatically connects the lowest numbered input with an active video signal to all outputs: 1A, 1B, 2A, and 2B. Auto-switching is automatically disabled when an input is received on the Output Select Control inputs.
Example:
Send the command [AUTO*] to the UT250-101. If a video input signal is connected to any of the inputs, that signal will be connected to all the outputs. A valid video signal on Input 1 takes precedence over Input 2, Input 2 over Input 3, and so on.
13.[AUTO0]
This command disables auto-switching.
Example:
Disable auto-switching mode by sending the command [AUTO0].
14.[AUTO1]
This command enables auto-switching to Output 1. The UT250-101automatically connects the lowest numbered input with an active video signal to Outputs 1A and 1B. Outputs 2A and 2B remain unchanged. Auto-switching is automatically disabled when an input is received on the Output Select Control inputs.
Example:
Send the command [AUTO1] to the UT250-101. If a video input signal is connected to any of the inputs, that signal will be connected to Outputs 1A and 1B only. A valid video signal on Input 1 takes precedence over Input 2, Input 2 over Input 3, and so on.
15.[AUTO2]
This command enables auto-switching to Output 2. The UT250-101automatically connects the lowest numbered input with an active video signal Outputs: 2A and 2B. Outputs 1A and 1B remain unchanged. Auto-switching is automatically disabled when an input is received on the Output Select Control inputs.
